Network Technologies SM-nXm-15V-LCD operation manual Change Output Port, Change Input Port

Page 29

NTI VEEMUX VIDEO MATRIX SWITCH

Change Output Port

Press the desired port number. If there is no change in the desired output port, the output port must still be selected. As the digits are selected, the last number entered will blink. The LCD will also display the current switch number followed by the decimal point.

With the desired port number selected, point the IRT at the switch/receiver and press the "OUT" button to transmit the selection and make the change. The blinking number in the LCD will stop blinking. An LED on the receiver will illuminate.

FYI: If the switch did not receive the data the LED will not illuminate. The user can re-send the same data by pressing the "OUT" button again. The LED at the receiver will illuminate to indicate a completed transmission from the IRT..

Note: If the number introduced is larger than the maximum number of outputs the IRT is configured for, then once the "OUT" key is pressed the LCD will display the current switch and the error signal "EE".

Change Input Port

Press the desired port number. As the digits are selected, the last number entered will blink. The LCD will also display the current switch number followed by the decimal point.

With the desired port number selected, point the IRT at the switch/receiver and press the "IN" button to transmit the selection and make the change. The blinking number in the LCD will stop blinking. The LED at the receiver will go OFF.

FYI: If the switch did not receive the data the LED will not go OFF. The user can re-send the same data by pressing the "IN" button again. The illuminated LED on the receiver will go OFF when the received data is complete.

Note: If the number introduced is larger than the maximum number of inputs that the IRT is configured to control, then once the "IN" key is pressed the LCD will display the current switch and the error signal "EE".

25

Page 28 Page 30
Image 29
Page 28 Page 30
Contents SM-nXm-15V-LCD Trademark Table of Contents Table of Figures Basic Operation IntroductionSupported Web Browsers CompatibiltyMaterials Default User Name and PasswordsCables Materials Supplied with this kitFront View of SM-8X8-15V-LCD Features and FunctionsPower ON/OFF switch Connect the Sources and Monitors InstallationConnect to the Ethernet 9D-male RS232 connectorConnect RS232 LED Matrix Power UpFront Panel LCD with Keypad Control Control OptionsEscape back to the main display Used to enter numbers. # Output user number can be enteredRemote Connection Scan ModeRS232 Control Baud Rate Command ProtocolUnit Address RS232 Matrix-Y-1 CPU Serial PortAutostatus Command Definitions ContdMatrix Operations SerTest- RS232 Interface Test ProgramMain Options Ethernet Operations Setup OptionsEthernet Control Command Reply DescriptionTelnet Interface Telnet 192.168.1.30Web Interface Enter the PasswordWeb interface Switch Video SwitchWeb interface Setup Setup PagesVideo Input Names Web interface Serial SetupOutput Names Scan ModeWeb interface Update Firmware Update FirmwareHelp Change PasswordUpdate Web Server Web interface Logout LogoutDevice Discovery Tool Device Discovery ToolInfrared Control Features And FunctionsKeypad LCD DisplayPower on with SYS, in or OUT keys Power on with 2 key How To Use The IRTChange the Switch Change Input Port Change Output PortSet Configuration Specifications Battery ReplacementIRT Troubleshooting Insert 2 new AA cell batteriesDDC Support Following will be needed RS232 Upgrade of the Front Panel LCD FirmwareNTI Veemux Video Matrix Switch Pinout of RS232 port on Veemux RS232 Connection CablesArrows indicate signal direction Wiring Schematic of Matrix-Y-1 cablePinout for Matrix Y-1 Cable Rack Mounting InstructionsNTI Desktop Size Rack Units Rack Size In. WxDxH SpecificationsSafety Statements TroubleshootingWarranty Information Index
Top Page Image Contents