Sun Microsystems X4150 manual Method 2 Using the Serial Connection, Example

Method 2: Using the Serial Connection

Example 1

To change the SP DHCP IP address to a static IP address using the serial connection (system management port):

1.Connect a terminal (or a PC running terminal emulation software) to the server serial port.

2.Ensure that the server hardware is installed and cables are inserted.

3.Verify that your terminal, laptop, PC, or terminal server is operational.

4.Configure the terminal device or the terminal emulation software running on a laptop or PC to the following settings:

■8,N,1: eight data bits, no parity, one stop bit

■9600 baud

■Disable hardware flow control (CTS/RTS)

■Disable software flow control (XON/XOFF)

5.Connect a null serial modem cable from the server’s back panel RJ45 serial port to a terminal device (if not connected already).

See FIGURE 1-4for the serial port position.

6.Press Enter on the terminal device to establish a connection between the terminal device and the LOM service processor (SP). The following prompt appears.

->

7.Type the default user name root, and then type the default password: changeme to log in to the LOM SP.

The LOM displays a default command prompt, indicating that you have successfully logged in:

->

8.Type the following command to determine the SP IP address: show /SP/network

9.After the status has been determined, view the output of show /SP/network.

■ELOM: IPSource = dhcp

■ILOM: ipdiscovery = dhcp

38 Sun Fire X4150 Server Installation Guide • May 2009