Paradyne Routers manual Extension to Interfaces Table RFC, IP Group RFC

Traps & MIBs

Extension to Interfaces Table (RFC 1573)

This extension contains additional objects for the Interface table. Table C-4 shows the objects supported.

Table C-4. Extension to Interfaces Table

Object	Description	Setting/Contents
ifName	Provides the name of the	Specifies the interface name:
(ifXEntry 1)	interface.	H dsl1 ± DSL interface.
		H eth1 ± Ethernet interface.
ifHighSpeed	Displays the downstream	Depending on the current mode of operation, displays the speed in
(ifXEntry 15)	speed for the DSL or	1 million bits per second (Mbps) of the Ethernet interface as:
	Ethernet interface in Mbps.	H 10 Mbps
		H 100 Mbps
		Due to the speed displaying as Mbps, the DSL interface downstream
		speed displays as 0 (zero).
ifConnector	Indicates whether there is	The value for all interfaces is always:
Present	a physical connector for	H true(1)
(ifXEntry 17)	the interface.

IP Group (RFC 1213)

The Internet Protocol Group objects are supported by the unit for all data paths that are currently configured to carry IP data to/from the unit. All of the objects in the IP Group, except for the IP Address Translation table, are fully supported. Table C-5provides clarification for objects contained in the IP Group.

Table C-5. IP Group Objects (1 of 2)

Object	Description	Setting/Contents
ipForwarding	Specifies whether the unit is acting	The value is read-only and always displays: (1)
(ip 1)	as an IP gateway for forwarding of
	datagram received by, but not
	addressed to, the DSL router.
ipDefaultTTL	TTL = Time To Live.	Minimum value ± 15. Maximum value ± 255.
(ip 2)		H 64 ± Default.
ipAddrTable	The address table.	The device sets the object ipAdEntReasmMaxSixe to
(ip 20)		16384. Supported as read-only.

6371-A2-GB20-10 August 2000 C-7