Paradyne Routers manual IP Cidr Route Group RFC

Page 80

Traps & MIBs

Table C-5. IP Group Objects (2 of 2)

Object

Description

Setting/Contents

ipNetToMediaTable

This table allows access to

This table is implemented with read/write access.

(ip 22)

contents of the ARP cache.

 

 

 

 

ipNetToMediaType

Supported for ARP table entries.

H other(1) ± Entry is incomplete.

(ipNetToMediaEntry

 

H invalid(2) ± Invalidates corresponding entry in the

4)

 

 

ipNetToMediaTable.

 

 

 

 

H dynamic(3) ± Results in a response with a badValue

 

 

error status. Dynamic ARP table entries will still

 

 

display with the correct dynamic (3) value, but a Set

 

 

is not allowed.

 

 

H static(4)

 

 

 

IP CIDR Route Group (RFC 2096)

This MIB obsoletes and replaces IP Group from MIB II. The IP CIDR Route Group objects are supported for all data paths currently configured to carry IP data to or from the device (i.e., the DSL and Ethernet interfaces). All of the objects in this group are fully supported except as noted in Table C-6. The IP Forwarding Group is not supported.

Table C-6. IP CIDR Route Group Objects (1 of 2)

Object

Description

Setting/Contents

 

 

 

ipCidrRouteTable

Replaces the ipRouteTable in

This is a read/write table. If an interface route is deleted

(ipForward 4)

MIB II. It adds knowledge of

but not the corresponding upstream route (such as with

 

autonomous system of the next

DHCP relay), an SNMP Get for this object will still show

 

hop, multiple next hops, policy

a table entry for the address and mask assigned to the

 

routing, and classless

interface.

 

inter-domain routing.

H reject(2) ± Value for route type and the

 

 

 

 

ipCidrRouteDownstreamValid will be false.

 

 

 

ipCidrRouteDest

Serves as an index to the

This object cannot take a Multicast (Class D) address

(ipCidrRouteEntry 1)

routing table.

value.

 

 

 

ipCidrRouteMask

This is the mask that is logical-

This is the mask before being compared to the value in

(ipCidrRouteEntry 2)

ANDed with the destination

the ipCidrRouteDest field.

 

address.

 

 

 

 

ipCidrRouteTos

The policy specifier is the IP

This object will always be 0 (zero).

(ipCidrRouteEntry 3)

Table of the Service field.

 

 

 

 

ipCidrRouteNextHop

The next hop route IP address

If there is no router, the value is 0.0.0.0.

(ipCidrRouteEntry 4)

for remote routes.

 

 

 

 

ipCidrRouteIfIndex

Corresponds to the IfIndex

Identifies the local interface through which the next hop

(ipCidrRouteEntry 5)

value.

of the route should be reached.

 

 

 

C-8

August 2000

6371-A2-GB20-10

Page 79 Page 81
Image 80
Page 79 Page 81
Contents HOTWIRE DSL Routers Copyright E 2000 Paradyne Corporation All rights reserved Contents Configuring the DSL Router Monitoring the DSL Router Index About This Guide Document Purpose and Intended AudienceDocument Summary Section DescriptionProduct-Related Documents Document Number Document TitleDocument Conventions Syntax TranslationDSL Technologies Supported Introduction to Hotwire DSL RoutersWhat is a Hotwire DSL Router? Optional Network Access Provider NAPTypical DSL Router System Hotwire DSL Router Features IP routing withService Subscriber Levels of Access Accessing the DSL RouterAccess Control to the DSL Router Changing Access Session Levels Local Console AccessAdmin enable Show consoleInvalid Characters Value Ascii Hex Translation Setting Up the New Users LoginCUSTOMER#. Type configure terminal and press Enter Telnet Access Determining the Current Access LevelDetermining the Available Commands Local console disabled by conflictChanging the System Identity Using the List CommandExiting from the System Automatically Logging Out If you are accessing the DSL router ThenManually Logging Out Interfaces for the DSL Router Configuring the DSL RouterOverview of DSL Router Configuration Service Domain IP Address Assignments Ethernet and DSL Interface IdentifiersSimplified Network Topology Numbered DSL InterfaceUnnumbered DSL Interface IP Routing Network ConsiderationsAddress Resolution Protocol ARP Proxy ARPNetwork Address Port Translation Napt Network Address Translation NATBasic NAT Applications Supported by NAT Dynamic Host Configuration Protocol Dhcp ServerIP Options Processing Dhcp Relay Agent Land Bug/Smurf Attack Prevention SecurityIP Filtering Routed Network Model Standard mode Routed vs. Bridged PDUsDSL Router Configuration Examples Configuration ExamplesBasic Configuration Example Customer Premises CPBasic NAT Configuration Example NAT Mapping Public IP Addresses Private IP AddressesNapt Configuration Example Napt Mapping Public IP Addresses Private IP AddressesCore Router 155.1.3.253 Console Port Connection Dhcp Relay with Proxy ARP Configuration Example Dhcp Server with Basic NAT Configuration Example Public IP Addresses for Basic NAT Private IP AddressesDownstream Router Configuration Example What to Monitor Detecting ProblemsMonitoring the DSL Router Status of Interfaces Show interfaceShow interface eth1 dsl1 ± Ethernet Link up downShow statistics eth1 dsl1 ip Interface StatisticsShow statistics Clearing Statistics List of Discard ReasonsClear statistics eth1 dsl1 ip Discard Reasons for the Ethernet Interface eth1 1Discard Reasons for the Ethernet Interface eth1 2 Discard Reasons for the DSL Interface dsl1 1Discard Reasons for the DSL Interface dsl1 2 Discard Reasons for IPDiagnostics and Troubleshooting Diagnostics and Troubleshooting OverviewAlarms Inquiry Show alarmsSyslog enable disable System LogShow syslog Syslog ip ip-addrSyslog Events Syslog level levelShow log number Syslog Messages 1 Level Description EventReporting Syslog Message DisplaySyslog Messages 2 Level Description Event Ping Ping Test ResultsPing reply x.x.x.x bytes of data=nn Ping reply x.x.x.x Request Timed OUTX.x TraceRouteTraceRoute Test Results Command Line Interface Command Line Interface FeatureDocument Conventions Command RecallNavigation Command Line Interface Commands Configuration Control CommandsRFC 1483 Encapsulation Ethernet Frame FormatInterface and Service Domain IP Address Ip route create dest-ipdest-mask next-hop-ip remote IP Routing TableDelete eth1ifn dsl1ifn Ip route purge ARP Table Proxy ARPNat basic enable Nat napt enableNat timeout time Nat basic address ip-addrip-maskNat basic delete private-ip Nat napt delete udp tcp portNat disable Dhcp server enable disableDhcp Server Nat purgeDhcp Relay Agent IP multicast enable disable IP processing enable disableTrap disable enable name of trap IP Packet ProcessingNAT disabled or NAT enabled basic NAT Napt Show Command OutputsShow config Show arp timeout NAT timeout xx minutes NAT basic mappingsShow ip route ip-address Show arpShow dhcp server Show NAT naptShow traps Show alarms Show syslog Show log # Show Dhcp relayShow interface Show statistics Sample show dhcp relay displayConfiguration Defaults Command Line Shortcuts Configuration Default SettingsParadyne Abc123Bytes CustomerCommand Line Input Shortcuts Table B-2. Command Line Input Shortcuts 1Table B-2. Command Line Input Shortcuts 2 Table B-2. Command Line Input Shortcuts 3 Show interface dsl1 eth1Configuration Defaults & Command Line Shortcuts Traps Overview Traps & MIBsSnmp Overview DSL Router Traps Variable BindingMIBs Overview Standard MIBsMIB II RFC System GroupSsssssssssss Boot bb.bb.bb 2nd Boot xx.xx.xx DSP SystemInterfaces Group RFC InterfacesIfEntry Yy.yy.yy H/W Releasezzz CCA part numberºIfOperStatus Specifies the current DSL interface IP Group RFC Table C-5. IP Group Objects 1 Description Setting/ContentsExtension to Interfaces Table RFC Table C-5. IP Group Objects 2 Description Setting/Contents IP Cidr Route Group RFCTransmission Group IpCidrRouteEntry 11 ±Snmp Group Ethernet-Like MIB RFCParadyne Enterprise MIBs Device Control MIBNoOp1 Active1Device Diagnostics MIB ApplpingTestEntry TracerouteAppTracerouteResultsEntry ConfigureApplTracerouteResultsEntry DevStatus Health and Status MIBDevStatus1 Configuration MIB Factory1-to-active8Interface Configuration MIB PdnInetIpAddressTableEntryPrimary SecondaryDhcp MIB DSL Endpoint MIB Syslog MIB DSL Router Terminal Emulation Accessing the List Command OutputDSL Router Terminal Emulation Terminal Emulation Programs Index NumbersIN-2 IN-3
Top Page Image Contents