Quatech QSC(LP)-100 user manual Windows

Page 16

5.3Windows 98

1.After inserting a QSC(LP)-100 for the first time, the "Add New Hardware Wizard will appear at start up. Click the "Next" button.

2.Select "Search for the best driver for your device". Click the "Next" button.

3.On the next dialog, select the "CD-ROM DRIVE" check box. Insert the Quatech COM CD (shipped with the device) into the CD-ROM drive. Click the "Next" button.

QSC(LP)-100 User's Manual

Image 16

Contents QSCLP-100 Warranty Information Iii Declaration of Conformity Enable Scratchpad Register SPAD, J2 Address Map and Special RegistersBase Address and Interrupt Level IRQ Enhanced Serial Adapter IdentificationGeneral Information Hardware Configuration Factory Default ConfigurationForce High-Speed Uart Clock X2, X4, or X8, J3-J5 Clock multiplier jumper optionsHardware Installation Jumper/connector locationsPort Address Range Enabling the Special Registers Interrupt Status RegisterOptions Register Bit Name DescriptionClock Rate Multiplier RR1 RR0Windows Configurations Windows MillenniumWindows Windows Using the New Hardware Found Wizard Viewing Resources with Device Manager Page Page Page Four-Port RS-232 Serial Adapter Page Page For legacy applicattions which cannot Page Page Other Operating Systems Windows NTOS/2 DOS and other operating systemsQTPCI.EXE QTPCI.EXE Expert Mode display External Connections RS-232 Port Signal PCI Resource Map INTA#Specifications ICL3245CAPage Troubleshooting Computer will not boot upQSCLP-100 Revision November