Quatech QSC(LP)-100 user manual Hardware Installation, Jumper/connector locations

Page 9

3Hardware Installation

1.Turn off the power of the computer system in which the QSC(LP)-100 is to be installed.

2.Remove the system cover according to the instructions provided by the computer manufacturer.

3.Make any desired optional jumper setting changes.

4.Install the QSC(LP)-100 in any empty PCI expansion slot. The board should be secured by installing the Option Retaining Bracket (ORB) screw.

5.Replace the system cover according to the instructions provided by the computer manufacturer.

6.Attach and secure the cable connectors to the desired equipment.

7.Turn on the power of the computer system.

The output of the QSC(LP)-100 is a 44-pin D-connector. A cable is provided to convert the D-44 into four standard male D-9 connectors with all control signals provided to each port (RTS, DTR, CTS, DSR, DCD, and RI).

Clock multiplier/

scratchpad select

SPAD

X8

X4

X2

Figure 5 --- Jumper/connector locations

QSC(LP)-100 User's Manual

9

Image 9
Contents QSCLP-100 Warranty Information Iii Declaration of Conformity Address Map and Special Registers Enable Scratchpad Register SPAD, J2Base Address and Interrupt Level IRQ Enhanced Serial Adapter IdentificationGeneral Information Factory Default Configuration Hardware ConfigurationClock multiplier jumper options Force High-Speed Uart Clock X2, X4, or X8, J3-J5Jumper/connector locations Hardware InstallationPort Address Range Interrupt Status Register Enabling the Special RegistersBit Name Description Options RegisterRR1 RR0 Clock Rate MultiplierWindows Millennium Windows ConfigurationsWindows Windows Using the New Hardware Found Wizard Viewing Resources with Device Manager Page Page Page Four-Port RS-232 Serial Adapter Page Page For legacy applicattions which cannot Page Page Windows NT Other Operating SystemsOS/2 DOS and other operating systemsQTPCI.EXE QTPCI.EXE Expert Mode display External Connections RS-232 Port Signal INTA# PCI Resource MapICL3245CA SpecificationsPage Computer will not boot up TroubleshootingQSCLP-100 Revision November