Quatech SSP-300, SSP-200 user manual Hardware Information, Auxiliary Channel Configuration

Page 43

6. Hardware Information

6.1 Auxiliary Channel Configuration

An auxiliary channel is provided which allows for handshaking between the SSP-200/300 port and a peripheral device. This auxiliary channel may be configured in one of two ways:

vRTS-CTS handshake enabled.

vhandshaking is disabled.

6.1.1 Auxiliary Channel: RTS-CTS Handshaking.

The RTS-CTS handshake may be enabled so that RTS (request to send) is the auxiliary output signal on AUX OUT+ (pin 1) and AUX OUT- (pin 6). Similarly, CTS (clear to send) is the auxiliary input signal on AUX IN+ (pin 5) and AUX IN- (pin 9). This configuration is shown below.

16C750 UART

TXD

RXD

-RTS

-CTS

RS-422/485

Drivers/Receivers

DATA OUT

Driver

DATA IN

Receiver

AUX OUT

Driver

AUX IN

Receiver

+

-

+

-

+

-

+

-

Figure 0. Auxiliary Channel RTS-CTS Handshaking

Hardware Information

6-1

Image 43
Contents SSP-200/300 SSP-200/300 Warranty InformationStandards to which Declaration of ConformityTable of Contents Introduction This page intentionally left blank DOS/Windows SSP-200/300 Client Driver for DOS Client Driver InstallationBaddress Command Line OptionsDevice = C\SSP-200\ SSP231CL.SYS Page Generic Client Drivers Common ProblemsAvailable Resources SSP-200/300 Enabler for DOSMultiple Configuration Attempts Older Versions of Card and Socket ServicesR option is not used Page Page Memory Range Exclusion Card and Socket Services SoftwareSocket Numbers Page SSP-200/300 Resource Settings in Windows 95/98/ME Installing a SSP-200/300 Under Windows 95/98/MEWindows 95/98/Millennium ME PC Card 1Viewing Resource Settings with Device Manager2Changing Resource Settings with Device Manager Start the Windows 95/98/ME Device ManagerISR Auxout Basic Configuration List Not Available Frequently Asked QuestionsBase I/O Address Resource Modification Not Allowed This page intentionally left blank Windows Installing a SSP-200/300 Under WindowsDouble click ‘Serial Port Adapters’ Double click ‘Drivers’ Page Manager SSP-200/300 Resource Settings in WindowsLPT Viewing Resource Settings with Device Manager Changing Resource Settings with Device Manager Page Data Rate Multiplier Page Page Basic Auxiliary Range RS-422/485 Clock Scratch 0012 Loopback Any RTS Controlled Auxout Windows NT Installing SSP-200/300Page Page Page Hardware Information Auxiliary Channel ConfigurationAuxiliary Channel RTS-CTS Handshaking Auxiliary Channel Handshaking Disabled Options Half Duplex OperationPage Recommended Termination Resistor Values Termination ResistorsThis page intentionally left blank SSP-200/300 Adapter Cable External ConnectionsThis page intentionally left blank Specifications SSP-200/300