Quatech SSP-300, SSP-200 user manual DOS/Windows

Page 7

2. DOS/Windows 3.x

Two configuration software programs are provided with the SSP-200/300: a Client Driver, and a card Enabler. Both of these programs are executed from DOS (before entering Windows) and allow operation of the SSP-200/300 in both the DOS and Windows 3.x environments. For optimal operation, however, the Client Driver is the preferred method of installation and configuration. The table below highlights the differences between these programs.

Client Driver (recommended)

Enabler

File type: DOS device driver

File type: DOS executable

Interfaces to PCMCIA Card and

Interfaces directly to Intel

Socket Services software

82365SL and other PCIC

(PCMCIA host adapter

compatible PCMCIA host

independent)

adapters

Allows automatic

Does not support automatic

configuration of SSP-200/300

configuration of adapters upon

adapters upon insertion (Hot

insertion (Hot Swapping)

Swapping)

 

Requires PCMCIA Card and

Does not require PCMCIA

Socket Services software

Card and Socket Services

 

software

Figure 0. Client Driver versus Enabler for DOS/Windows 3.x.

Card and Socket Services software is commercially available from several vendors for most desktop and laptop PCs. If you are unsure whether Card and Socket Services software is currently installed on your system, install the SSP-200/300 Client Driver as discussed in following section. When loaded, the Client Driver will display an error message if Card and Socket Services software is not detected.

DOS/Windows 3.x

2-2

Image 7
Contents SSP-200/300 SSP-200/300 Warranty InformationStandards to which Declaration of ConformityTable of Contents Introduction This page intentionally left blank DOS/Windows SSP-200/300 Client Driver for DOS Client Driver InstallationBaddress Command Line OptionsDevice = C\SSP-200\ SSP231CL.SYS Page Generic Client Drivers Common ProblemsAvailable Resources SSP-200/300 Enabler for DOSMultiple Configuration Attempts Older Versions of Card and Socket ServicesR option is not used Page Page Memory Range Exclusion Card and Socket Services SoftwareSocket Numbers Page SSP-200/300 Resource Settings in Windows 95/98/ME Installing a SSP-200/300 Under Windows 95/98/MEWindows 95/98/Millennium ME PC Card 1Viewing Resource Settings with Device Manager2Changing Resource Settings with Device Manager Start the Windows 95/98/ME Device ManagerISR Auxout Basic Configuration List Not Available Frequently Asked QuestionsBase I/O Address Resource Modification Not Allowed This page intentionally left blank Windows Installing a SSP-200/300 Under WindowsDouble click ‘Serial Port Adapters’ Double click ‘Drivers’ Page Manager SSP-200/300 Resource Settings in WindowsLPT Viewing Resource Settings with Device Manager Changing Resource Settings with Device Manager Page Data Rate Multiplier Page Page Basic Auxiliary Range RS-422/485 Clock Scratch 0012 Loopback Any RTS Controlled Auxout Windows NT Installing SSP-200/300Page Page Page Hardware Information Auxiliary Channel ConfigurationAuxiliary Channel RTS-CTS Handshaking Auxiliary Channel Handshaking Disabled Options Half Duplex OperationPage Recommended Termination Resistor Values Termination ResistorsThis page intentionally left blank SSP-200/300 Adapter Cable External ConnectionsThis page intentionally left blank Specifications SSP-200/300