Quatech SSP-300, SSP-200 Frequently Asked Questions, Basic Configuration List Not Available

Page 23

SSP-200/300 PCMCIA serial ports with these applications you might be forced to remove other serial communications devices from your system

7.To modify the Interrupt Request setting click the resource name and click the Change Setting button. An Edit Resource window will open up. Inside this window click on the up/down arrows to the right of the Interrupt Request value. This scrolls you through all of the allowable resources for your hardware. Pay attention to the conflict information at the bottom of the window. Do not select a value that causes a conflict with any other installed hardware.

8.If any changes have been made to the SSP-200/300’s configuration the card will automatically be reconfigured to the new resources specified. Any time a PCMCIA card of this type is inserted Windows 95/98/ME will attempt to configure the card at these resource settings. Click the Use Automatic Settings box to reset this card type for automatic configuration.

3.3Frequently Asked Questions

Basic Configuration List Not Available:

A problem noted on some systems is after a basic configuration has been manually selected the basic configurations list for the SSP-200/300 is no longer available. The solution to this problem is to check the “Use Automatic Settings” box and allow Windows 95/98/ME to reconfigure the SSP-200/300 card. The basic configurations list should once again be visible.

Base I/O Address Resource Modification Not Allowed:

The SSP-200/300 is configured to allow only a fixed number of base I/O addresses. To change the I/O address resources for the SSP-200/300 select another “Basic Configuration.” Refer to the Basic Configurations table for a list of the availabe I/O address resources for the SSP-200/300

Windows 95/98/Millennium (ME)

3-5

Image 23
Contents SSP-200/300 SSP-200/300 Warranty InformationStandards to which Declaration of ConformityTable of Contents Introduction This page intentionally left blank DOS/Windows SSP-200/300 Client Driver for DOS Client Driver InstallationBaddress Command Line OptionsDevice = C\SSP-200\ SSP231CL.SYS Page Generic Client Drivers Common ProblemsAvailable Resources SSP-200/300 Enabler for DOSMultiple Configuration Attempts Older Versions of Card and Socket ServicesR option is not used Page Page Socket Numbers Card and Socket Services SoftwareMemory Range Exclusion Page Windows 95/98/Millennium ME Installing a SSP-200/300 Under Windows 95/98/MESSP-200/300 Resource Settings in Windows 95/98/ME PC Card 1Viewing Resource Settings with Device Manager2Changing Resource Settings with Device Manager Start the Windows 95/98/ME Device ManagerISR Auxout Base I/O Address Resource Modification Not Allowed Frequently Asked QuestionsBasic Configuration List Not Available This page intentionally left blank Windows Installing a SSP-200/300 Under WindowsDouble click ‘Serial Port Adapters’ Double click ‘Drivers’ Page Manager SSP-200/300 Resource Settings in WindowsLPT Viewing Resource Settings with Device Manager Changing Resource Settings with Device Manager Page Data Rate Multiplier Page Page Basic Auxiliary Range RS-422/485 Clock Scratch 0012 Loopback Any RTS Controlled Auxout Windows NT Installing SSP-200/300Page Page Page Auxiliary Channel RTS-CTS Handshaking Auxiliary Channel ConfigurationHardware Information Auxiliary Channel Handshaking Disabled Options Half Duplex OperationPage Recommended Termination Resistor Values Termination ResistorsThis page intentionally left blank SSP-200/300 Adapter Cable External ConnectionsThis page intentionally left blank Specifications SSP-200/300