Quatech RS-422 user manual Windows

Page 21

5.3Windows 98

1.After inserting a DSCLP-200/300 for the first time, the "Add New Hardware Wizard will appear at start up. Click the "Next" button.

2.Select "Search for the best driver for you device". Click the "Next" button.

3.On the next dialog, select the "CD-ROM DRIVE" check box. Insert the Quatech

COM CD (shipped with the device) into the CD-ROM drive. Click the "Next" button.

16	DSCLP/SSCLP-200/300 User's Manual

Image 21

Contents DSCLP-200/300 Page Serial Number Declaration of Conformity Table of Contents General Information RS-422 or RS-485 Signal Line Termination Hardware ConfigurationFull-duplex/Half-duplex Operation Signal Connections1 CTS0SEL, CTS1SEL J10,17 2 AUX0SEL1,0, AUX1SEL1,0 J12,11,19,18RCLK0SEL, RCLK1SEL J13 4 TGL0SEL1,0, TGL1SEL1,0 J15,14,22,21 Enable Scratchpad Register SPAD, J2RXEN0SEL, RXEN1SEL J16 Clock Rate and Optional RegistersForce High-Speed Uart Clock X2 or X4, J4-J5 Enable scratchpad registersX4 mode Jumper/connector locations Hardware InstallationBase Address and Interrupt Level IRQ Address Map and Special RegistersInterrupt Status Register Enabling the Special RegistersQuatech Modem Control Register Quatech Modem Control RegisterEnhanced Serial Adapter Identification Options RegisterRR1 RR0 Clock Rate MultiplierWindows Millennium Windows ConfigurationsWindows Windows Windows Using the New Hardware Found Wizard Viewing Resources with Device Manager Page Page Page Windows NT Other Operating SystemsOS/2 DOS and other operating systemsQTPCI.EXE Basic Mode display QTPCI.EXE Expert Mode display Jumper/Channel correspondence External ConnectionsRclk RTS/CTS HandshakeAUXIN/AUXOUT Loopback XclkHalf-Duplex/Full-Duplex Selection Half- or full-duplex selection RS-422/485 Line termination resistance values Termination ResistorsRS-422/485 Peripheral Connection DSCLP-200/300 connector definitionsINTA# PCI Resource MapWith 64-byte FIFOs optional SpecificationsComputer will not boot up TroubleshootingDSCLP-200/300 Revision December