Quatech RS-422 user manual

Page 2

?2002 Quatech, Inc.

NOTICE

The information contained in this document cannot be reproduced in any form without the written consent of Quatech, Inc. Likewise, any software programs that might accompany this document can be used only in accordance with any license agreement(s) between the purchaser and Quatech, Inc. Quatech, Inc. reserves the right to change this documentation or the product to which it refers at any time and without notice.

The authors have taken due care in the preparation of this document and every attempt has been made to ensure its accuracy and completeness. In no event will Quatech, Inc. be liable for damages of any kind, incidental or consequential, in regard to or arising out of the performance or form of the materials presented in this document or any software programs that might accompany this document.

Quatech, Inc. encourages feedback about this document. Please send any written comments to the Technical Support department at the address listed on the cover page of this document.

DOS, Windows 95, Windows NT are trademarks or registered trademarks of Microsoft Corporation. OS/2 is a registered trademark of IBM Corporation. All other trademarks or registered trademarks are property of their respective owners.

iv

DSCLP-200/300 User's Manual

Image 2
Contents DSCLP-200/300 Page Serial Number Declaration of Conformity Table of Contents General Information Hardware Configuration RS-422 or RS-485 Signal Line TerminationSignal Connections Full-duplex/Half-duplex OperationRCLK0SEL, RCLK1SEL J13 1 CTS0SEL, CTS1SEL J10,172 AUX0SEL1,0, AUX1SEL1,0 J12,11,19,18 RXEN0SEL, RXEN1SEL J16 Enable Scratchpad Register SPAD, J24 TGL0SEL1,0, TGL1SEL1,0 J15,14,22,21 Clock Rate and Optional RegistersEnable scratchpad registers Force High-Speed Uart Clock X2 or X4, J4-J5X4 mode Hardware Installation Jumper/connector locationsAddress Map and Special Registers Base Address and Interrupt Level IRQEnabling the Special Registers Interrupt Status RegisterQuatech Modem Control Register Quatech Modem Control RegisterOptions Register Enhanced Serial Adapter IdentificationClock Rate Multiplier RR1 RR0Windows Configurations Windows MillenniumWindows Windows Windows Using the New Hardware Found Wizard Viewing Resources with Device Manager Page Page Page OS/2 Other Operating SystemsWindows NT DOS and other operating systemsQTPCI.EXE Basic Mode display QTPCI.EXE Expert Mode display External Connections Jumper/Channel correspondenceRTS/CTS Handshake RclkXclk AUXIN/AUXOUT LoopbackHalf-Duplex/Full-Duplex Selection Half- or full-duplex selection Termination Resistors RS-422/485 Line termination resistance valuesDSCLP-200/300 connector definitions RS-422/485 Peripheral ConnectionPCI Resource Map INTA#Specifications With 64-byte FIFOs optionalTroubleshooting Computer will not boot upDSCLP-200/300 Revision December