Quatech RS-422 user manual PCI Resource Map, Inta#

Page 37

8 PCI Resource Map

Listed below are the PCI resources used by the DSCLP-200/300. Such information may be of use to customers writing their own device drivers or other custom software. A detailed description of the DSCLP-200/300's UARTs is available on the Quatech web site.

(all numbers in hex)
PCI Vendor ID:	0x135C	Quatech, Inc.
PCI Device ID:0x0030DSCLP-200/300
PCI Class Code
Base class:	0x07	Simple communications controller
Subclass:	0x02	Multiport serial controller
Interface:	0x00
IRQ sourced by:	INTA#
Base address 0:	0x80 bytes I/O	Reserved region
Base address 1:	0x10 bytes I/O	Serial ports
		Port 1 at offset 0x00
		Port 2 at offset 0x08

32	DSCLP/SSCLP-200/300 User's Manual

Image 37

Contents DSCLP-200/300 Page Serial Number Declaration of Conformity Table of Contents General Information RS-422 or RS-485 Signal Line Termination Hardware ConfigurationFull-duplex/Half-duplex Operation Signal Connections2 AUX0SEL1,0, AUX1SEL1,0 J12,11,19,18 1 CTS0SEL, CTS1SEL J10,17RCLK0SEL, RCLK1SEL J13 4 TGL0SEL1,0, TGL1SEL1,0 J15,14,22,21 Enable Scratchpad Register SPAD, J2RXEN0SEL, RXEN1SEL J16 Clock Rate and Optional RegistersForce High-Speed Uart Clock X2 or X4, J4-J5 Enable scratchpad registersX4 mode Jumper/connector locations Hardware InstallationBase Address and Interrupt Level IRQ Address Map and Special RegistersInterrupt Status Register Enabling the Special RegistersQuatech Modem Control Register Quatech Modem Control RegisterEnhanced Serial Adapter Identification Options RegisterRR1 RR0 Clock Rate MultiplierWindows Millennium Windows ConfigurationsWindows Windows Windows Using the New Hardware Found Wizard Viewing Resources with Device Manager Page Page Page Windows NT Other Operating SystemsOS/2 DOS and other operating systemsQTPCI.EXE Basic Mode display QTPCI.EXE Expert Mode display Jumper/Channel correspondence External ConnectionsRclk RTS/CTS HandshakeAUXIN/AUXOUT Loopback XclkHalf-Duplex/Full-Duplex Selection Half- or full-duplex selection RS-422/485 Line termination resistance values Termination ResistorsRS-422/485 Peripheral Connection DSCLP-200/300 connector definitionsINTA# PCI Resource MapWith 64-byte FIFOs optional SpecificationsComputer will not boot up TroubleshootingDSCLP-200/300 Revision December