Quatech DSCLP/SSCLP-100 user manual Enabling the Special Registers, Interrupt Status Register

Page 11

4.2 Enabling the Special Registers

The DSCLP-100 contains two unique registers, an Interrupt Status Register and an Options Register. These registers are enabled when the SPAD jumper (J2) is removed (factory default). They replace the UART Scratchpad Register on accesses to register address 7.

The Interrupt Status Register and Options Register are accessed through the scratchpad location of any UART. The DLAB bit of the UART (Line Control Register, bit 7) is used to select between the two registers. The most recent write of a DLAB bit in any UART selects between the two registers as shown in Figure 7.

DLAB Bit

SPAD Jumper

Register selected for

address 7 accesses

 

 

0

removed

Interrupt Status Register

1

removed

Options Register

X

applied

Scratchpad Registers

Figure 7 --- DLAB bit selects between special registers

4.3 Interrupt Status Register

The read-only Interrupt Status Register can be used to quickly identify which serial ports require servicing after an interrupt. Reading the Interrupt Status Register will return the interrupt status of the entire DSCLP-100, as shown in Figure 8. The individual bits are cleared as the interrupting ports are serviced. The interrupt service routine should ensure that the interrupt status register reads zero before exiting.

Bit

Description

 

 

7 (MSB)

0 (not used)

6

0 (not used)

 

 

5

0 (not used)

4

0 (not used)

 

 

3

0 (not used)

 

 

2

0 (not used)

1

Port 2 --- 1 if interrupt pending

 

 

0

Port 1 --- 1 if interrupt pending

Figure 8 --- Interrupt Status Register

11

DSCLP/SSCLP-100 User's Manual

Image 11
Contents DSCLP/SSCLP-100 Warranty Information Page Declaration of Conformity Enhanced Serial Adapter Identification Windows ConfigurationsAddress Map and Special Registers Base Address and Interrupt Level IRQGeneral Information Enable Scratchpad Register SPAD, J2 Hardware ConfigurationFactory Default Configuration Clock multiplier jumper options Jumper/connector locations Hardware InstallationPort Address Range Interrupt Status Register Enabling the Special RegistersBit Name Description Options RegisterRR1 RR0 Clock Rate MultiplierWindows Millennium Windows Windows Windows Using the New Hardware Found Wizard Page Viewing Resources with Device Manager Page Page Dual-Port RS-232 Serial Adapter Page Page For legacy applicattions which cannot Page Page DOS and other operating systems Other Operating SystemsWindows NT OS/2QTPCI.EXE QTPCI.EXE Expert Mode display External Connections RS-232 Port Signal SSCLP-100 PCI Resource MapICL3245CA SpecificationsPage Computer will not boot up TroubleshootingDSCLP/SSCLP-100