Patton electronic 1063, 07MOS10xx-GS manual Mounting the OS-10 System in an Etsi 300-mm Rack

Page 31

OnSite Series Getting Started Guide	3 • Installation Overview

Note Do not cover vents that would restrict airﬂow. Leave a minimum of a half-rack space above and below the OS-10 system for adequate ven- tilation.

3.Secure the chassis using four 12-24 x 3/4-inch screws (two screws for each side) through the elongated holes in the L bracket nearest to the chassis and to the threaded holes in the mounting post. Use a suitable screwdriver for this task.

4.Tighten any loose captive installation screws on the expansion slot front panel covers.

Figure 11. Mounting the OS-10 System in an ETSI 300-mm Rack

OnSite System Installation

31

Image 31

Contents Metro-Optical Transport Access Nodes Mailsupport@patton.com Summary Table of Contents Table of Contents System Management Access Terms and Acronyms List of Figures List of Tables Audience About this guideStructure PrecautionsGeneral conventions Typographical conventions used in this documentMouse conventions Power Cable Safety when using electricityFiber-Optic Ports Optical SafetyFiber-Optic Safety Precautions Electrostatic Discharge DamageProduct Overview Chapter contentsOnSite Platforms IntroductionSDH Trunks OS1052 Base System Application Overview Typical OS1052 application OS1052 ApplicationOS1052 Map + Modules Typical OS1063 application OS1063 ApplicationOS1063 Map + Modules Installation Overview Site Preparation Unpacking and InspectionPlanning Your Site Site EnvironmentSite Requirements Operating Environment Requirements Power Supply Requirements Securing the Rack Mechanical Recommendations for the RackProtective Grounding for the Rack and Chassis Space Requirements for the RackOnSite System Installation Tools and Equipment for Installation and MaintenanceMounting the Chassis to an EIA/TIA 19-Inch Rack Mounting the OS-10 System Chassis in an EIA/TIA 19-Inch Rack Mounting the Chassis to an Etsi RackMounting the OS-10 System in an Etsi 300-mm Rack Mounting the OS-10 System Chassis on a Wall Mounting the Chassis on the WallConnecting Power to the OS-10 System Installing the Chassis Ground ConnectionConnecting AC Power to the OS-10 System Powering On the OS-10 System with AC Power Wiring the OS-10 System for DC Power Installation Overview Checking the OS-10 System Installation System Management Access General Overview Detail of the Management Ports Ethernet LAN Management PortSerial Management Port Provides the pin assignments for the RJ-45 connectorAccess through the Serial Port Gaining Access to the SystemAccess through the Ethernet LAN Management Port Launching the GUI Application Web-Based Management InterfaceGUI Frames Provides Conﬁguring an Snmp Trap Receiver Autonomous Alarm MessagesConﬁguring an Authorized OnSight NMS Server Location of EOW port AUX 1 on OS-10 Series Chassis Engineering Orderwire EOWSystem Management Access Conﬁguring the Engineering Orderwire EOW Function System Management Access Contacting Patton for assistance Contact information Warranty coverageRMA numbers Return for credit policyAppendix a Compliance information FCC Part 68 Acta Statement SafetyCompliance Radio and TV InterferenceAuthorized European Representative Declaration of ConformityAppendix B Speciﬁcations Model OS1052 Operations DimensionsWeight PowerModel OS1063 Operations Appendix C Terms and Acronyms Abbreviation Meaning AbbreviationsLcas TDM