Polycom 4400 manual 802.11b 70 dBm Mb/s 60 dBm 11 Mb/s 802.11a 45 dBm 54 Mb/s

Page 14

Configuration Guide

require the following minimum dBm reading to support the corresponding Mandatory data rate setting in the access point.

	802.11		Minimum Available	Maximum
	Radio Standard		Signal Strength (RSSI)	“Mandatory” Data Rate
	802.11b		-70 dBm	1 Mb/s
	802.11b		-60 dBm	11 Mb/s
			-60 dBm	11 Mb/s

	802.11a		-60 dBm	6 Mb/s
	802.11a		-45 dBm	54 Mb/s
			-45 dBm	54 Mb/s

For additional details on RF deployment please see the Deploying

Enterprise-GradeWi-Fi Telephony white paper and the Best

Practices Guide for Deploying SpectraLink 8020/8030 Wireless

Telephones.

14	PN: 1725-36070-001_P.doc

Image 14

Contents Cisco Trademark Information Introduction Certified Product SummaryKnown Limitations Network Topology Configuring a New Controller Starting from Factory Defaults Connecting to the Controller via a Browser Installing Software Controller Setup Initial setup of the controller is shown belowConnecting APs Under Interface Name click managementServer AP Configuration Set Admin Status to Enable 802.11b 70 dBm Mb/s 60 dBm 11 Mb/s 802.11a 45 dBm 54 Mb/s Use the default Fragmentation Threshold 2346 bytes Configuration Guide Set Admin Status to Enable Use the default Fragmentation Threshold 2346 bytes For 802.11a Network Status, click the Enabled check box Setting Up the SSIDs Setting up the voice SsidPN 1725-36070-001P.doc Configuration Guide Further Assistance