Polycom 4400 manual Set Admin Status to Enable

Page 13

Cisco: 4400 Series WLC, WiSM and 3750G Integrated WLC with 1100 and 1200 Series APs

4.Set Admin Status to Enable.

5.Configure any other settings that might be relevant to your deployment as needed.

6.Click the Apply button to save all changes.

7.In the navigation pane under 802.11b/g/n, select Network.

8.Set 802.11b/g Network Status to Disable. The radio will be re- enabled after setting radio parameters

For setting up the Data Rates, please consult your facility’s RF site survey, designed for voice traffic, to determine if you have sufficient coverage to support all data rates. SpectraLink Wireless Telephones

PN: 1725-36070-001_P.doc

13

Image 13
Contents Cisco Trademark Information Certified Product Summary IntroductionKnown Limitations Network Topology Configuring a New Controller Starting from Factory Defaults Connecting to the Controller via a Browser Installing Software Initial setup of the controller is shown below Controller Setup Under Interface Name click management Connecting APsServer AP Configuration Set Admin Status to Enable 802.11b 70 dBm Mb/s 60 dBm 11 Mb/s 802.11a 45 dBm 54 Mb/s Use the default Fragmentation Threshold 2346 bytes Configuration Guide Set Admin Status to Enable Use the default Fragmentation Threshold 2346 bytes For 802.11a Network Status, click the Enabled check box Setting up the voice Ssid Setting Up the SSIDsPN 1725-36070-001P.doc Configuration Guide Further Assistance