Polycom 4400 manual Configuration Guide

Page 16

Configuration Guide

Configuration for SpectraLink Wireless Telephones running in 802.11a mode

1.From the main menu, click Wireless.

2.In the navigation pane, under Access Points select Radios, then select 802.11a /n. All the APs that are connected should be listed, showing their Operational Status as UP.

3.Select Configure from the drop-down list for the access point you wish to change.

Global settings for RF Channel Assignment and Tx Power Level Assignment were not tested during VIEW Certification. For Custom Tx Power and RF Channel settings please consult your facility’s RF site survey — optimized for wireless voice traffic — to determine correct power and channel settings for each AP using non- overlapping channels.

16

PN: 1725-36070-001_P.doc

Image 16
Contents Cisco Trademark Information Introduction Certified Product SummaryKnown Limitations Network Topology Configuring a New Controller Starting from Factory Defaults Connecting to the Controller via a Browser Installing Software Controller Setup Initial setup of the controller is shown belowConnecting APs Under Interface Name click managementServer AP Configuration Set Admin Status to Enable 802.11b 70 dBm Mb/s 60 dBm 11 Mb/s 802.11a 45 dBm 54 Mb/s Use the default Fragmentation Threshold 2346 bytes Configuration Guide Set Admin Status to Enable Use the default Fragmentation Threshold 2346 bytes For 802.11a Network Status, click the Enabled check box Setting Up the SSIDs Setting up the voice SsidPN 1725-36070-001P.doc Configuration Guide Further Assistance