Polycom 4400 manual Trademark Information

Page 2

Configuration Guide

Trademark Information

Polycom® and the logo designs SpectraLink®

LinkPlus Link NetLink

SVP

Are trademarks and registered trademarks of Polycom, Inc. in the United States of America and various countries. All other trademarks used herein are the property of their respective owners.

Patent Information

The accompanying product is protected by one or more US and foreign patents and/or pending patent applications held by Polycom, Inc.

Copyright Notice

Copyright © 2006 to 2009 Polycom, Inc.

All rights reserved under the International and pan-American copyright Conventions.

No part of this manual, or the software described herein, may be reproduced or transmitted in any form or by any means, or translated into another language or format, in whole or in part, without the express written permission of Polycom, Inc.

Do not remove (or allow any third party to remove) any product identification, copyright or other notices.

Every effort has been made to ensure that the information in this document is accurate. Polycom, Inc. is not responsible for printing or clerical errors. Information in this document is subject to change without notice and does not represent a commitment on the part of Polycom, Inc.

Notice

Polycom, Inc. has prepared this document for use by Polycom personnel and customers. The drawings and specifications contained herein are the property of Polycom and shall be neither reproduced in whole or in part without the prior written approval of Polycom, nor be implied to grant any license to make, use, or sell equipment manufactured in accordance herewith.

Polycom reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult Polycom to determine whether any such changes have been made.

NO REPRESENTATION OR OTHER AFFIR- MATION OF FACT CONTAINED IN THIS DOCUMENT INCLUDING BUT NOT LIMITED TO STATEMENTS REGARDING CAPACITY, RESPONSE-TIME PERFORMANCE, SUITABILITY FOR USE, OR PERFORMANCE OF PRODUCTS DESCRIBED HEREIN SHALL BE DEEMED TO BE A WARRANTY BY POLYCOM FOR ANY PURPOSE, OR GIVE RISE TO ANY LIABILITY OF POLYCOM WHATSOEVER.

Contact Information

Please contact your Polycom Authorized Reseller for assistance.

Polycom, Inc.

4750 Willow Road, Pleasanton, CA 94588 http://www.polycom.com

2

PN: 1725-36070-001_P.doc

Image 2
Contents Cisco Trademark Information Introduction Certified Product SummaryKnown Limitations Network Topology Configuring a New Controller Starting from Factory Defaults Connecting to the Controller via a Browser Installing Software Controller Setup Initial setup of the controller is shown belowConnecting APs Under Interface Name click managementServer AP Configuration Set Admin Status to Enable 802.11b 70 dBm Mb/s 60 dBm 11 Mb/s 802.11a 45 dBm 54 Mb/s Use the default Fragmentation Threshold 2346 bytes Configuration Guide Set Admin Status to Enable Use the default Fragmentation Threshold 2346 bytes For 802.11a Network Status, click the Enabled check box Setting Up the SSIDs Setting up the voice SsidPN 1725-36070-001P.doc Configuration Guide Further Assistance