Polycom 4400 manual Connecting to the Controller via a Browser

Page 7

Cisco: 4400 Series WLC, WiSM and 3750G Integrated WLC with 1100 and 1200 Series APs

Connecting to the Controller via a Browser

1.Connect to the WLC by pointing your internet browser to the URL: https<IP_Addr> (where <IP_Addr> is the IP address of the management interface of the WLC).

2.Click the Login prompt. The default User Name and Password is admin.

3.Once logged in properly, a page similar to the one below displays.

PN: 1725-36070-001_P.doc

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Cisco Trademark Information Certified Product Summary Introduction Known Limitations Network Topology Configuring a New Controller Starting from Factory Defaults Connecting to the Controller via a Browser Installing Software Initial setup of the controller is shown below Controller SetupUnder Interface Name click management Connecting APsServer AP Configuration Set Admin Status to Enable 802.11b 70 dBm Mb/s 60 dBm 11 Mb/s 802.11a 45 dBm 54 Mb/s Use the default Fragmentation Threshold 2346 bytes Configuration Guide Set Admin Status to Enable Use the default Fragmentation Threshold 2346 bytes For 802.11a Network Status, click the Enabled check box Setting up the voice Ssid Setting Up the SSIDsPN 1725-36070-001P.doc Configuration Guide Further Assistance
Top Page Image Contents