Polycom 4400 manual Setting Up the SSIDs, Setting up the voice Ssid

Page 20

Configuration Guide

Setting Up the SSIDs

It is required for voice and data to be on separate SSIDs to prioritize voice traffic. The voice SSID must be set to Platinum for Quality of Service (as shown in the screen shot below) and the data SSID must be set to Silver for Quality of Service.

Setting up the voice SSID

1.From the main menu, click WLANs.

2.In the WLANs screen, click the New…. button.

3.Type the Profile Name and the WLAN SSID name.

4.Click the Apply button.

20	PN: 1725-36070-001_P.doc

Image 20

Contents Cisco Trademark Information Introduction Certified Product SummaryKnown Limitations Network Topology Configuring a New Controller Starting from Factory Defaults Connecting to the Controller via a Browser Installing Software Controller Setup Initial setup of the controller is shown belowConnecting APs Under Interface Name click managementServer AP Configuration Set Admin Status to Enable 802.11b 70 dBm Mb/s 60 dBm 11 Mb/s 802.11a 45 dBm 54 Mb/s Use the default Fragmentation Threshold 2346 bytes Configuration Guide Set Admin Status to Enable Use the default Fragmentation Threshold 2346 bytes For 802.11a Network Status, click the Enabled check box Setting Up the SSIDs Setting up the voice SsidPN 1725-36070-001P.doc Configuration Guide Further Assistance