Polycom 1725-36082-001 manual Nortel Wlan Security Switch 2300 Series with AP-2330

Page 7

Nortel: WLAN Security Switch 2300 Series with AP-2330

Configuring a New WLAN Security Switch Starting from Factory Defaults

1.Using the supplied DB-9 male to DB-9 female standard RS-232 cable, connect the WLAN Security Switch to the serial port of a terminal or PC.

2.Run a terminal emulation program (such as HyperTerminal) or use a VT-100 terminal with the following configuration:

Bits per second:

9600

Data bits:

8

Parity:

None

Stop bits:

1

Flow control:

None

3.Power-on the WLAN Security Switch. The status of the boot process will appear in the console as the switch is powering up. Once the switch is operational you will be presented with a login prompt.

4.A Quick Start Wizard provides for an easy means to perform initial WLAN Security Switch setup and configuration. Refer to the WLAN Security Switch 2300 Series Quick Start Guide found at Nortel’s Technical Support site. This document contains a detailed explanation of using the Startup Wizard: http://support.nortel.com/go/main.jsp?cscat=DOCDETAIL&id= 583095&poid=16021

5.Once the WLAN Security Switch has been configured via the Quick Start Wizard, the remaining configuration can be performed using command line interface (CLI), Web View or WLAN Management Software (WMS). Configuration examples will be provided for both CLI and WMS.

6.If necessary, the WLAN Security Switch may be reset to factory defaults. To reset the WLAN Security Switch to factory defaults, you must issue the “clear boot config” command via the console.

PN: 1725-36082-001_G.doc

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Nortel Trademark Information Certified Product Summary IntroductionContacting Nortel Technical Support Known LimitationsNetwork Topology Access Point Capacity and Positioning Nortel Wlan Security Switch 2300 Series with AP-2330 Directly connected APs Connecting APsDistributed APs Command, comment, and screen text key AP configuration Configuration Example CLIVlan configuration Set service-profile Voice ssid-name Voice Service profile / Ssid configurationAccess control list Radio Profile configurationSaving changes To save the current changes to a WSS using CLIAdding a Wlan Security Switch to the Network Plan Configuration Example Wlan Management SoftwareDistributed AP or Directly Connected AP Configuration Guide To configure the 802.11g Radio To configure the 802.11a Radio Network Plan Tasks panel, select Create Vlan For Vlan Name enter Voice Network Plan Tasks panel, select Igmp Service Profile / Ssid configuration Specify a Name and Ssid for the Voice Service Profile Select the Open Access check box. Click the Next button Settings for Wireless Encryption Cipher Suite Configuration Guide Nortel Wlan Security Switch 2300 Series with AP-2330 Click the Next button Nortel Wlan Security Switch 2300 Series with AP-2330 Radio Profile configuration Radio Profile Properties window, click the Radio Profile tab Configuration Guide Deploying changes Configuration Guide Example Configuration Files For Reference Only Configuration Guide Nortel Wlan Security Switch 2300 Series with AP-2330
Top Page Image Contents