TP-Link TL-WDN4800 manual 450Mbps Wireless N Dual Band PCI Express Adapter

Page 19

TL-WDN4800

450Mbps Wireless N Dual Band PCI Express Adapter

1.Edit the General tab

¾Profile Name - Please enter the Profile name which identifies the configuration profile. This name must be unique. Note that the profile names are not case-sensitive.

¾Client Name - Please enter a name which identifies the client machine.

¾Network Names (SSIDs) - Please enter the IEEE 802.11 wireless network name. This field has a maximum limit of 32 characters.

Figure 3-3

2.Edit the Security tab

Select the Security tab in the screen above, and then you can edit the fields to configure the profile. To define the security mode, select the radio button of the desired security mode as follows.

13

Image 19

Contents Rev 1.1.0 TL-WDN4800 450Mbps Wireless N Dual Band PCI Express AdapterCOPYRIGHT & TRADEMARKS FCC RF Radiation Exposure Statement FCC STATEMENTRestriction CE Mark WarningNational restrictions CountryShenzhen, P. R. China DECLARATION OF CONFORMITYCONTENTS Conventions Package Contents450Mbps Wireless N Dual Band PCI Express Adapter Chapter 1. Introduction 1.2 Features1.1 Overview of the product Flashing Slowly 1.3 LED StatusThe driver has not been installed The driver has been installed but there is no data being transmitted2.1 Hardware Installation Chapter 2. Installation Guide2.2 Software Installation 2. Click Install Driver&Utility to load the following screen TL-WDN4800 5. Click Browse to change the destination location for the software, or you can leave it default then click Next in the screen below shown in Figure 8. Wait a while for the setup as shown in Figure TL-WDN4800 3.1 For Windows XP Chapter 3. Configuration Guide¾ Wireless Mode - Here displays the wireless mode 3.1.2 Profile Management ¾ Profile Name - Please enter the Profile name which identifies the configuration profile. This name must be unique. Note that the profile names are not case-sensitive The WEP security mode is not available for 802.11n ¾ WPA/WPA2 Wi-Fi Protected Access¾ WPA/WPA2 Passphrase Wi-Fi Protected Access Passphrase ¾ 802.1x Enables 802.1x security450Mbps Wireless N Dual Band PCI Express Adapter ¾ Network Type There are basically two modes of networking 1. Go to the Profile Management tab shown in Figure 3. Click Remove 2. Click Refresh to refresh the list at any time 4. Highlight a profile in the Auto Selected Profiles box 3.1.3 Diagnostics 3.2 For Windows Vista Icon means the connection has been established. Icon means there is no connection. To establish a connection, please follow the steps below 3.3 For Windows 1. Click the icon at the bottom of your screen in your system tray and then you will see the available wireless network list. Select the SSID of your Access Point and click Connect TL-WDN4800 Chapter 4. QSS Configuration 4.1 PBC Push Button Configuration method TL-WDN4800 There are two ways to configure the QSS by PIN method 4.2 PIN method1 Enter a PIN into your AP device 2 Enter the PIN from your AP device 4.2.1 Enter a PIN into your AP device 4.2.2 Enter the PIN from your AP device Appendix A Specifications Appendix B Glossary scale, or when it is necessary to connect the wired and wireless networks

Related manuals

Manual 2 pages 27.54 Kb

Manual 47 pages 28.13 Kb

Manual 53 pages 17.51 Kb