TP-Link TL-WDN4800 manual 450Mbps Wireless N Dual Band PCI Express Adapter

Page 25

2.Click Refresh to refresh the list at any time.

TL-WDN4800

450Mbps Wireless N Dual Band PCI Express Adapter

Figure 3-9

3.1.2.6. Scan Available Networks

1.Click Scan on the Profile Management screen (shown in Figure 3-2X), the Available Infrastructure and Ad Hoc Networks window will appear below.

2.Click Refresh to refresh the list at any time.

3.Highlight a network name and click Activate to connect to an available network. If no configuration profile exists for that network, the Profile Management window will open the General tab screen. Fill in the Profile name and click OK to create the configuration profile for that network.

Figure 3-10

19

Image 25

Contents Rev 1.1.0 TL-WDN4800 450Mbps Wireless N Dual Band PCI Express AdapterCOPYRIGHT & TRADEMARKS FCC RF Radiation Exposure Statement FCC STATEMENTNational restrictions CE Mark WarningCountry RestrictionShenzhen, P. R. China DECLARATION OF CONFORMITYCONTENTS Conventions Package Contents450Mbps Wireless N Dual Band PCI Express Adapter Chapter 1. Introduction 1.2 Features1.1 Overview of the product The driver has not been installed 1.3 LED StatusThe driver has been installed but there is no data being transmitted Flashing Slowly2.1 Hardware Installation Chapter 2. Installation Guide2.2 Software Installation 2. Click Install Driver&Utility to load the following screen TL-WDN4800 5. Click Browse to change the destination location for the software, or you can leave it default then click Next in the screen below shown in Figure 8. Wait a while for the setup as shown in Figure TL-WDN4800 3.1 For Windows XP Chapter 3. Configuration Guide¾ Wireless Mode - Here displays the wireless mode 3.1.2 Profile Management ¾ Profile Name - Please enter the Profile name which identifies the configuration profile. This name must be unique. Note that the profile names are not case-sensitive ¾ WPA/WPA2 Passphrase Wi-Fi Protected Access Passphrase ¾ WPA/WPA2 Wi-Fi Protected Access¾ 802.1x Enables 802.1x security The WEP security mode is not available for 802.11n450Mbps Wireless N Dual Band PCI Express Adapter ¾ Network Type There are basically two modes of networking 1. Go to the Profile Management tab shown in Figure 3. Click Remove 2. Click Refresh to refresh the list at any time 4. Highlight a profile in the Auto Selected Profiles box 3.1.3 Diagnostics 3.2 For Windows Vista Icon means the connection has been established. Icon means there is no connection. To establish a connection, please follow the steps below 3.3 For Windows 1. Click the icon at the bottom of your screen in your system tray and then you will see the available wireless network list. Select the SSID of your Access Point and click Connect TL-WDN4800 Chapter 4. QSS Configuration 4.1 PBC Push Button Configuration method TL-WDN4800 There are two ways to configure the QSS by PIN method 4.2 PIN method1 Enter a PIN into your AP device 2 Enter the PIN from your AP device 4.2.1 Enter a PIN into your AP device 4.2.2 Enter the PIN from your AP device Appendix A Specifications Appendix B Glossary scale, or when it is necessary to connect the wired and wireless networks

Related manuals

Manual 2 pages 27.54 Kb

Manual 47 pages 28.13 Kb

Manual 53 pages 17.51 Kb