Using the Polycom PowerCam Presenter
2.Do one of the following:
—If you are planning to enable automatic zooming for the Presenter View, stand 20 feet (6 meters) to 30 feet (9 meters) from the camera. (If your room is smaller, you may have to stand closer.)
—If you are not planning to enable automatic zooming for the Presenter
View, stand at the distance at which that Presenter View will be used. For example, if you are going to use the Left Presenter View when the presenter is standing near the whiteboard, then stand near the whiteboard when setting that Presenter View. 
3.Use 
Left, 
Right, 
Up, 
Down, or 
Zoom to adjust the camera to the position you want for the particular Presenter View button.
4.Press 
Auto Zoom if you want to enable automatic zooming for the Presenter View. (This setting is disabled by default.)
Polycom recommends that you enable automatic zooming for the Presenter View under these conditions:
—You are going to set the Wide Presenter View.
—Your distance from the camera is going to vary more than 5 feet (1½ meters). For example, if you plan on standing about 8 feet (2 meters) to 12 feet (4 meters) from the camera during your entire presentation, you do not need to enable automatic zooming (although you may still enable it if you wish). If, on the other hand, you expect to walk anywhere from 4 feet (1 meter) to 30 feet (9 meters) from the camera during your presentation, you should definitely enable automatic zooming.
5.Press and hold the Presenter View button that corresponds to the camera’s current position. For example, you can press Tight Tight if you have set the camera so that it’s zoomed in closely on the presenter.
Hold the button for at least five seconds or, if you have your video output connected to connector 
on the Polycom Presenter controller, until the following icon appears on the screen:
This icon remains on the screen for three seconds.
6.Repeat steps 2 through 5 for each Presenter View button that you want to set or change.
2 - 13