|
| Using the Polycom PowerCam Presenter |
|
|
|
|
|
|
| Setting | Description |
|
|
|
| Subnet Mask | Displays the subnet mask currently assigned to the |
|
| system. |
|
| If the system does not automatically obtain a |
|
| subnet mask, enter one here. |
|
| Changing this setting causes the system to restart. |
|
|
|
| WINS Server | Displays the WINS server currently assigned to the |
|
| system. |
|
| If the system does not automatically obtain a WINS |
|
| server IP address, enter one here. |
|
| Changing this setting causes the system to restart. |
|
|
|
| WINS Resolution | Specifies whether to send a request to the WINS |
|
| server for WINS name resolution. |
|
|
|
| LAN Speed | Specifies the LAN speed to use. Select Auto if you |
|
| want the network switch to negotiate the speed |
|
| automatically; otherwise, select either 10 Mbps or |
|
| 100 Mbps. |
|
| Note: Be sure that the LAN Speed setting for the |
|
| PowerCam Presenter and for the switch are the |
|
| same. Typically, selecting Auto for both is |
|
| sufficient. Polycom recommends that you do not |
|
| select Auto for either just the PowerCam Presenter |
|
| or just the switch; the settings for both must exactly |
|
| match. |
|
| Changing this setting causes the system to restart. |
|
|
|
| Duplex Mode | Specifies the Duplex Mode to use. Select Auto if |
|
| you want the network switch to negotiate the |
|
| Duplex Mode automatically; otherwise, select |
|
| either Full or Half. |
|
| Note: Be sure that the Duplex Mode you choose is |
|
| supported by the switch. |
|
|
|
Configuring Video Output Settings
The Video Output Settings screen lets you specify the video output signal from
connector 
on the PowerCam Presenter controller.
To configure the video output settings:
1.Press 
Menu on the remote control.
2.Select Video Output Settings from the PowerCam Presenter screen.
2 - 9