Kramer Electronics user manual Rgbs and RGsB PINOUTs, Connecting to the VP-725XLA via RS-232

Connecting the VP-725XLA Presentation Switcher / Scaler

6.2 The RGBS and RGsB PINOUTs

Table 3 defines the input progressive1 and interlaced2 RGBS and RGsB pinouts:

Table 3: RGBS and RGsB PINOUTS

Input	Color Space	PINOUT
VGA	RGsB	Red to PIN 1
		Green + sync, to PIN 2
		Blue to PIN 3
	RGBS	Red to PIN 1
		Green to PIN 2
		Blue to PIN 3
		Hs (H and V) to PIN 13
YUV	YPbPr	Green + sync to Y
		Blue to Pb
		Red to Pr

6.3 Connecting to the VP-725XLA via RS-232

You can connect to the unit via a crossed RS-232 connection, using for example, a PC. A crossed cable or null-modem is required as shown in method A and B respectively. If a shielded cable is used, connect the shield to pin 5.

Method A (Figure 4)—Connect the RS-232 9-pin D-sub port on the unit via a crossed cable (pin 2 to pin 3, pin 3 to pin 2, and pin 5 to pin 5) to the RS-232 9- pin D-sub port on the PC.

Note: There is no need to connect any other pins.

Figure 4: Crossed Cable RS-232 Connection

Hardware flow control is not required for this unit. In the rare case where a controller requires hardware flow control, short pin 1 to 7 and 8, and pin 4 to 6 on the controller side.

Method B (Figure 5)—Connect the RS-232 9-pin D-sub port on the unit via a straight (flat) cable to the null-modem adapter, and connect the null-modem adapter to the RS-232 9-pin D-sub port on the PC. The straight cable usually

1 A display mode in which all the horizontal lines of an image are displayed in a single frame (one field)

2 A display mode in which a frame consists of two separate fields with the first field consisting of odd horizontal lines and the second field even horizontal lines

16 KRAMER: SIMPLE CREATIVE TECHNOLOGY