Configuring and Controlling the
Setting | Function | Selection/Range | Default |
Factory Reset | Reset your | Confirm, Yes, No |
|
| settings |
|
|
Advanced | Open the advanced setups (see Figure 21) | Mode Set (see Table 14) |
|
Setup |
| OSD (see Table 15) |
|
|
| Misc. (see Table 16) |
|
|
| Input (see Table 17) |
|
|
| Output (see Table 18) |
|
EDID EEPROM | EDID writing protection1 | On/Off |
|
Protect |
|
|
|
HDMI Switch | Set to DVD/Normal or PC/Bypass | Normal2/Bypass | Normal |
Behavior |
|
|
|
8.1.8The Slideshow Feature
The
To prepare a slideshow:
1.Load the slideshow JPEG3 images to a USB memory stick. The slides will appear in alphabetical order.
2.Open the Setup menu and set the desired speed in the slideshow item and then close the menu.
3.Connect the Memory stick to the USB connector on the front panel.
4.Select the USB INPUT button on the front panel. The slideshow begins at the set speed.
You have to set the slideshow parameters before you run the slideshow
You can control the slide show by pressing the:
•FREEZE button to pause
•USB button to play and stop the slideshow
•Up button to go to the previous slide
•Down button to go to the next slide
1 When an EDID file update is required, set the EDID protection to OFF. Note that this function might not be available for old hardware versions. In this case, this feature will be grayed out
2 Set to Normal for sources with HDCP. When in Normal operation, the unit sends a hot plug to the source for any Group/Scaler switching request. There might be some graphic cards that might shut OFF the VGA/HDMI output following the hot plug detection. To prevent this, set this parameter to the Bypass mode so the unit will not send a hot plug for switching request (the hot plug will be detected by the source only when plugging a physical connection). Note that this function might not be available for old hardware versions. In this case, this feature will be grayed out
3 JPEG files are recognized up to 2048x1536
36 | KRAMER: SIMPLE CREATIVE TECHNOLOGY |