Kramer Electronics user manual Connecting the VP-725XLA Presentation Switcher / Scaler

Connecting the VP-725XLA Presentation Switcher / Scaler

6 Connecting the VP-725XLA Presentation Switcher / Scaler

This section describes how to connect the VP-725XLA. In particular, how to connect the:

•VP-725XLArear panel (see this section 6.1)

•Interlaced and progressive RGBS and RGsB inputs (see section 6.2)

•PC (see section 6.3)

•Ethernet port (see section 6.4)

•Audio inputs/outputs (see section 6.5)

Using the VP-725XLAyou can select any one of the 21 inputs and scale that input to up to three scaled outputs (at the identical resolution).

6.1 Connecting the VP-725XLA

To connect the VP-725XLA, connect the following1 to the rear panel, as the example in Figure 3 illustrates:

1.Connect one or more of the following video sources:

Up to four UXGA graphics sources (for example, computers) to the 15-pin HD input connectors2

Up to four composite video sources (for example, DVD players) to the BNC input connectors

Up to four s-Video sources to the 4-pin input connectors (not illustrated in Figure 3)

Up to four component video3 (sometimes called YUV, or Y, B-Y, R-Y, or Y, Pb/Cb, Pr/Cr) sources or four RGB sources to the four sets of 3 BNC connectors, G/Y, B/Pb, and R/Pr.

Up to four HDMI sources (for example, DVD players) to the HDMI connectors

1 Switch OFF the power on each device before connecting it to your VP-725XLA. After connecting your VP-725XLA, switch on its power and then switch on the power on each device

2 These connectors also accept interlaced and progressive RGBS and RGsB signals (see Table 3)

3 For example, an HDTV satellite receiver to COMP IN 1 and an RGB camera connected to COMP IN 4

13