Kramer Electronics VP-725XLA user manual Defines the settings available for each application

Configuring and Controlling the VP-725XLA

8.1.6The Geometry Screen

Figure 19 and Table 11 define the Geometry screen, allowing the user flexibility in positioning his projector relative to the screening surface.

Figure 19: Geometry Screen

Table 11: Geometry Screen Functions

Setting	Function	Selection/Range	Default
Application	Select the output application	Keystone, Anyplace or Rotation	Keystone
Location	Select the location of the display	Front, Ceiling, Rear or Rear	Front
		ceiling
Horizontal Keystone	Adjust the horizontal keystone1	-40 to 40	0
Vertical Keystone	Adjust the vertical keystone2	-30 to 30	0
Diagonal Projection	Move the location of each corner	Top Left, Top Right, Bottom Left,	Top Left
	of the display separately3	Bottom Right or Reset (to reset
		diagonal projections settings)
Pincushion/Barrel	Adjust the pincushion or barrel	-20 to 20	0
	appearance of the screen4
Rotation	Rotate the display clockwise or	-180 to 180	0
	counterclockwise (in 1°
	increments)
Reset all	Resets the geometry setting to its default values

Table 12 defines the settings available for each application:

1 If the projector is located at an angle to the left or right of the screen 2 If the projector is located at an angle above or below the screen

3 Horizontally and vertically

4 For projection onto curved surfaces

34 KRAMER: SIMPLE CREATIVE TECHNOLOGY