Kenwood TK-2200, TK-3200 instruction manual Pack from the charger

Page 13

Plug the AC adaptor cable into the

1 adaptor jack located at the rear of the charger.

2Plug the AC adaptor into an AC outlet.

Slide the Ni-MH battery pack or transceiver with a Ni-MH battery pack into the charger.

		Make sure the battery pack terminals
	3	are in contact with the charger
	3	terminals by aligning the grooves of
		terminals by aligning the grooves of
		the battery pack with the tabs of the
		charger.
		The charger LED lights red and
		charging begins.

When charging is completed, the indicator lights green. Remove the battery pack or the transceiver with a battery

4	pack from the charger.
	It takes approximately 3 hours to charge the battery pack.

When the charger will not be used for a long time, unplug the AC adapter from the AC outlet.

Image 13

Contents

TK-2200 Thank YOU Operating Conditions FCC License Information Explosive Atmospheres GASES, DUST, FUMES, etc IiiOne or more of the following statements may be applicable Page Contents Unpacking and Checking Equipment Warranty card B62-1791-XXQuantity Jack cover Rapid battery charger AC adaptor Ni-MH battery packAntenna optional OrientationPreparation Pack from the charger INSTALLING/ Removing the Battery Pack Installing the Optional Antenna Installing the Cover Over the SPEAKER/ Microphone Jacks Rotate the Channel selector to select your desired channel Getting StartedVoice Operated Transmission VOX Turning the transceiver power onPress and hold the Lock key while VOX Gain level and the Scan key Press the Lock key to increaseTo decrease the level To exit VOX mode, set the VOX Gain level page 10 to OFF To stop transmitting, stop speakingKEY Functions To end Scan, press the Scan key again To start scanning, press the Scan keyBackground Operations Quiet Talk QT/ Digital Quiet Talk DQT TK-2200 K2 TK-3200 K2 Channel Model Channel Setup ModeRotate the Channel selector to your Release the PTT switch and Lock keyDesired channel Press the Lock key to incrementOFF TK-2200 OperatingTK-3200 Operating Press the Lock key or Scan key to select QT or DQT setup New tone or code Tone number or the Scan key toOff QT Channel Settings103.5 Hz 167.9 Hz 107.2 Hz 173.8 Hz DQT DQT Channel SettingsFunction Name KEY Assignment ModeBe reprogrammed either the Lock key Continue to press and hold the key toOr the Scan key, while releasing Remaining keyOperation will cancel To save the setting, otherwiseTurn the transceiver power OFF Calling Alert MONITOR/ Squelch OFF Temporary Delete Transceiver power on ALL Reset ModeScan key while turning Release the keysOptional Accessories Problem Solution Troubleshooting GuideBattery pack may be dead

Kenwood TK-2200, TK-3200 instruction manual Pack from the charger

pack from the charger.