Kenwood TK-2200, TK-3200 instruction manual Iii, Explosive Atmospheres GASES, DUST, FUMES, etc

Page 5

PRECAUTIONS

•Refer service to qualified technicians only. Do not modify or attempt to adjust this transceiver for any reason.

•Do not expose the transceiver to long periods of direct sunlight, nor place it close to heating appliances.

•Do not place the transceiver in excessively dusty, humid, or wet areas, nor on unstable surfaces.

•Avoid extreme exposure to heat and cold. This transceiver can be used in mild weather conditions and is not waterproof.

•Do not operate your transceiver or charge your battery pack in an explosive atmosphere (gases, dust, fumes, etc.).

•If an abnormal odor or smoke is detected coming from the transceiver, immediately switch OFF the power and remove the battery pack from the transceiver. Contact your KENWOOD dealer.

NOTICES TO THE USER

◆Government law prohibits the operation of unlicensed radio transmitters within the territories under government control.

◆Illegal operation is punishable by fine and/or imprisonment.

◆Refer service to qualified technicians only.

Safety: It is important that the operator is aware of, and understands, hazards common to the operation of any transceiver.

EXPLOSIVE ATMOSPHERES (GASES, DUST, FUMES, etc.)

Turn off your transceiver while taking on fuel, or while parked in gasoline service stations.

iii

Page 4 Page 6
Image 5
Page 4 Page 6
Contents
TK-2200 Thank YOU Operating Conditions FCC License Information Explosive Atmospheres GASES, DUST, FUMES, etc IiiOne or more of the following statements may be applicable Page Contents Quantity Warranty card B62-1791-XXUnpacking and Checking Equipment Jack cover Rapid battery charger AC adaptor Ni-MH battery packAntenna optional OrientationPreparation Pack from the charger INSTALLING/ Removing the Battery Pack Installing the Optional Antenna Installing the Cover Over the SPEAKER/ Microphone Jacks Rotate the Channel selector to select your desired channel Getting StartedPress and hold the Lock key while Turning the transceiver power onVoice Operated Transmission VOX To decrease the level Press the Lock key to increaseVOX Gain level and the Scan key To exit VOX mode, set the VOX Gain level page 10 to OFF To stop transmitting, stop speakingKEY Functions To end Scan, press the Scan key again To start scanning, press the Scan keyBackground Operations Quiet Talk QT/ Digital Quiet Talk DQT TK-2200 K2 TK-3200 K2 Channel Model Channel Setup ModeRotate the Channel selector to your Release the PTT switch and Lock keyDesired channel Press the Lock key to incrementOFF TK-2200 OperatingTK-3200 Operating Press the Lock key or Scan key to select QT or DQT setup New tone or code Tone number or the Scan key to103.5 Hz 167.9 Hz 107.2 Hz 173.8 Hz QT Channel SettingsOff DQT DQT Channel SettingsFunction Name KEY Assignment ModeBe reprogrammed either the Lock key Continue to press and hold the key toOr the Scan key, while releasing Remaining keyTurn the transceiver power OFF To save the setting, otherwiseOperation will cancel Calling Alert MONITOR/ Squelch OFF Temporary Delete Transceiver power on ALL Reset ModeScan key while turning Release the keysOptional Accessories Battery pack may be dead Troubleshooting GuideProblem Solution