Kenwood TK-2200, TK-3200 Press the Lock key to increase, VOX Gain level and the Scan key

Page 19

 

Press the Lock key to increase the

 

VOX Gain level and the Scan key

 

to decrease the level.

3

The VOX Gain can be adjusted from

level 1 to level 10 and OFF.

The transceiver announces the VOX Gain level as you adjust it. If OFF is selected, the transceiver announces “Off”.

4

5

1

Press the PTT switch within 5 seconds to save the setting, otherwise the operation will cancel.

A beep will sound and the transceiver will announce the new VOX Gain level.

Turn the transceiver power OFF and then ON again to activate VOX.

Note:

◆VOX Gain level 1 is the least sensitive and VOX Gain level 10 is the most sensitive.

◆If a speaker/ microphone is connected to the transceiver while the VOX function is switched ON and the VOX Gain level is configured to a higher, more sensitive level, louder received signals may cause the transceiver to start transmission.

◆The transceiver will automatically return to normal operation if no action is performed for 5 seconds.

11

Page 18 Page 20
Image 19
Page 18 Page 20
Contents
TK-2200 Thank YOU Operating Conditions FCC License Information Explosive Atmospheres GASES, DUST, FUMES, etc IiiOne or more of the following statements may be applicable Page Contents Unpacking and Checking Equipment Warranty card B62-1791-XXQuantity Jack cover Rapid battery charger AC adaptor Ni-MH battery packAntenna optional OrientationPreparation Pack from the charger INSTALLING/ Removing the Battery Pack Installing the Optional Antenna Installing the Cover Over the SPEAKER/ Microphone Jacks Rotate the Channel selector to select your desired channel Getting StartedVoice Operated Transmission VOX Turning the transceiver power onPress and hold the Lock key while VOX Gain level and the Scan key Press the Lock key to increaseTo decrease the level To exit VOX mode, set the VOX Gain level page 10 to OFF To stop transmitting, stop speakingKEY Functions To end Scan, press the Scan key again To start scanning, press the Scan keyBackground Operations Quiet Talk QT/ Digital Quiet Talk DQT TK-2200 K2 TK-3200 K2 Channel Model Channel Setup ModePress the Lock key to increment Release the PTT switch and Lock keyRotate the Channel selector to your Desired channelOFF TK-2200 OperatingTK-3200 Operating Press the Lock key or Scan key to select QT or DQT setup New tone or code Tone number or the Scan key toOff QT Channel Settings103.5 Hz 167.9 Hz 107.2 Hz 173.8 Hz DQT DQT Channel SettingsFunction Name KEY Assignment ModeRemaining key Continue to press and hold the key toBe reprogrammed either the Lock key Or the Scan key, while releasingOperation will cancel To save the setting, otherwiseTurn the transceiver power OFF Calling Alert MONITOR/ Squelch OFF Temporary Delete Release the keys ALL Reset ModeTransceiver power on Scan key while turningOptional Accessories Problem Solution Troubleshooting GuideBattery pack may be dead