Kenwood TK-2200, TK-3200 instruction manual To save the setting, otherwise, Operation will cancel

Page 35

 

Press the PTT switch within 5 seconds

 

to save the setting, otherwise the

5

operation will cancel.

 

A beep will sound and the transceiver

 

will announce the new Table number.

 

Turn the transceiver power OFF and

6

then ON again to activate the new

1

settings.

Note: The transceiver will automatically return to normal operation if no action is performed for 5 seconds.

27

Page 34 Page 36
Image 35
Page 34 Page 36
Contents
TK-2200 Thank YOU Operating Conditions FCC License Information Explosive Atmospheres GASES, DUST, FUMES, etc IiiOne or more of the following statements may be applicable Page Contents Quantity Warranty card B62-1791-XXUnpacking and Checking Equipment Jack cover Rapid battery charger AC adaptor Ni-MH battery packAntenna optional OrientationPreparation Pack from the charger INSTALLING/ Removing the Battery Pack Installing the Optional Antenna Installing the Cover Over the SPEAKER/ Microphone Jacks Rotate the Channel selector to select your desired channel Getting StartedPress and hold the Lock key while Turning the transceiver power onVoice Operated Transmission VOX To decrease the level Press the Lock key to increaseVOX Gain level and the Scan key To exit VOX mode, set the VOX Gain level page 10 to OFF To stop transmitting, stop speakingKEY Functions To end Scan, press the Scan key again To start scanning, press the Scan keyBackground Operations Quiet Talk QT/ Digital Quiet Talk DQT TK-2200 K2 TK-3200 K2 Channel Model Channel Setup ModePress the Lock key to increment Release the PTT switch and Lock keyRotate the Channel selector to your Desired channelOFF TK-2200 OperatingTK-3200 Operating Press the Lock key or Scan key to select QT or DQT setup New tone or code Tone number or the Scan key to103.5 Hz 167.9 Hz 107.2 Hz 173.8 Hz QT Channel SettingsOff DQT DQT Channel SettingsFunction Name KEY Assignment ModeRemaining key Continue to press and hold the key toBe reprogrammed either the Lock key Or the Scan key, while releasingTurn the transceiver power OFF To save the setting, otherwiseOperation will cancel Calling Alert MONITOR/ Squelch OFF Temporary Delete Release the keys ALL Reset ModeTransceiver power on Scan key while turningOptional Accessories Battery pack may be dead Troubleshooting GuideProblem Solution