Kenwood TK-3200, TK-2200 instruction manual Installing the Cover Over the SPEAKER/ Microphone Jacks

Page 16

INSTALLING THE COVER OVER THE SPEAKER/ MICROPHONE JACKS

If you are not using a speaker/ microphone, install the cover over the speaker/ microphone jacks using the supplied 3 x 6 mm screw.

Note: To keep the transceiver water resistant, you must cover the speaker/ microphone jacks with the supplied cover.

INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE (OR HEADSET)

1

2

Insert the speaker/ microphone

(or headset) plugs into the speaker/ microphone jacks.

Note: Always switch OFF the transceiver power when installing or removing a speaker/ microphone or headset.

Attach the locking bracket using the supplied 3 x 6 mm screw.

Note: The transceiver is not fully water resistant while using the speaker/ microphone.

8

Image 16

Contents

TK-2200 Thank YOU Operating Conditions FCC License Information Iii Explosive Atmospheres GASES, DUST, FUMES, etcOne or more of the following statements may be applicable Page Contents Unpacking and Checking Equipment Warranty card B62-1791-XXQuantity Rapid battery charger AC adaptor Ni-MH battery pack Jack coverOrientation Antenna optionalPreparation Pack from the charger INSTALLING/ Removing the Battery Pack Installing the Optional Antenna Installing the Cover Over the SPEAKER/ Microphone Jacks Getting Started Rotate the Channel selector to select your desired channelVoice Operated Transmission VOX Turning the transceiver power onPress and hold the Lock key while VOX Gain level and the Scan key Press the Lock key to increaseTo decrease the level To stop transmitting, stop speaking To exit VOX mode, set the VOX Gain level page 10 to OFFKEY Functions To start scanning, press the Scan key To end Scan, press the Scan key againBackground Operations Quiet Talk QT/ Digital Quiet Talk DQT Channel Setup Mode TK-2200 K2 TK-3200 K2 Channel ModelRelease the PTT switch and Lock key Rotate the Channel selector to yourDesired channel Press the Lock key to incrementTK-2200 Operating OFFTK-3200 Operating Press the Lock key or Scan key to select QT or DQT setup Tone number or the Scan key to New tone or codeOff QT Channel Settings103.5 Hz 167.9 Hz 107.2 Hz 173.8 Hz DQT Channel Settings DQTKEY Assignment Mode Function NameContinue to press and hold the key to Be reprogrammed either the Lock keyOr the Scan key, while releasing Remaining keyOperation will cancel To save the setting, otherwiseTurn the transceiver power OFF Calling Alert MONITOR/ Squelch OFF Temporary Delete ALL Reset Mode Transceiver power onScan key while turning Release the keysOptional Accessories Problem Solution Troubleshooting GuideBattery pack may be dead