Kenwood TK-2200, TK-3200 instruction manual KEY Assignment Mode, Function Name

Page 33

KEY ASSIGNMENT MODE

This transceiver allows you to reprogram the Lock and Scan keys with any of the functions listed in the table below. Explanations on the use of each function are provided on the following pages.

Table Number	Function Name

0	None (no function)

1	Calling Alert

2	Key Lock

3	Super Lock (Lock key default)

4	Monitor

5	Monitor Momentary

6	Scan

7	Scan + Temporary Delete (Scan key default)

8	Scrambler

9	Squelch Off

10	Squelch Off Momentary

11	Temporary Delete

25

Image 33

Contents

TK-2200 Thank YOU Operating Conditions FCC License Information Explosive Atmospheres GASES, DUST, FUMES, etc IiiOne or more of the following statements may be applicable Page Contents Warranty card B62-1791-XX Unpacking and Checking EquipmentQuantity Jack cover Rapid battery charger AC adaptor Ni-MH battery packAntenna optional OrientationPreparation Pack from the charger INSTALLING/ Removing the Battery Pack Installing the Optional Antenna Installing the Cover Over the SPEAKER/ Microphone Jacks Rotate the Channel selector to select your desired channel Getting StartedTurning the transceiver power on Voice Operated Transmission VOXPress and hold the Lock key while Press the Lock key to increase VOX Gain level and the Scan keyTo decrease the level To exit VOX mode, set the VOX Gain level page 10 to OFF To stop transmitting, stop speakingKEY Functions To end Scan, press the Scan key again To start scanning, press the Scan keyBackground Operations Quiet Talk QT/ Digital Quiet Talk DQT TK-2200 K2 TK-3200 K2 Channel Model Channel Setup ModeRotate the Channel selector to your Release the PTT switch and Lock keyDesired channel Press the Lock key to incrementOFF TK-2200 OperatingTK-3200 Operating Press the Lock key or Scan key to select QT or DQT setup New tone or code Tone number or the Scan key toQT Channel Settings Off103.5 Hz 167.9 Hz 107.2 Hz 173.8 Hz DQT DQT Channel SettingsFunction Name KEY Assignment ModeBe reprogrammed either the Lock key Continue to press and hold the key toOr the Scan key, while releasing Remaining keyTo save the setting, otherwise Operation will cancelTurn the transceiver power OFF Calling Alert MONITOR/ Squelch OFF Temporary Delete Transceiver power on ALL Reset ModeScan key while turning Release the keysOptional Accessories Troubleshooting Guide Problem SolutionBattery pack may be dead