Kenwood TK-2200, TK-3200 instruction manual Installing the Optional Antenna

Page 15

INSTALLING THE OPTIONAL ANTENNA

Screw the antenna into the connector on the top of the transceiver by holding the antenna at its base and turning it clockwise until secure.

Note: The antenna is neither a handle, a key ring retainer, nor a speaker/ microphone attachment point. Using the antenna in these ways may damage the antenna and degrade your transceiver’s performance.

INSTALLING THE BELT CLIP

If necessary, attach the belt clip using the two supplied 3 x 8 mm screws.

Note: If the belt clip is not installed, its mounting location may get hot during continuous transmission or when left sitting in a hot environment.

Do not use glue which is designed to prevent screw loosening when installing the belt clip, as it may cause damage to the transceiver. Acrylic ester, which is contained in these glues, may crack the transceiver’s back panel.

7

Image 15

Contents

TK-2200 Thank YOU Operating Conditions FCC License Information Explosive Atmospheres GASES, DUST, FUMES, etc IiiOne or more of the following statements may be applicable Page Contents Warranty card B62-1791-XX Unpacking and Checking EquipmentQuantity Jack cover Rapid battery charger AC adaptor Ni-MH battery packAntenna optional OrientationPreparation Pack from the charger INSTALLING/ Removing the Battery Pack Installing the Optional Antenna Installing the Cover Over the SPEAKER/ Microphone Jacks Rotate the Channel selector to select your desired channel Getting StartedTurning the transceiver power on Voice Operated Transmission VOXPress and hold the Lock key while Press the Lock key to increase VOX Gain level and the Scan keyTo decrease the level To exit VOX mode, set the VOX Gain level page 10 to OFF To stop transmitting, stop speakingKEY Functions To end Scan, press the Scan key again To start scanning, press the Scan keyBackground Operations Quiet Talk QT/ Digital Quiet Talk DQT TK-2200 K2 TK-3200 K2 Channel Model Channel Setup ModePress the Lock key to increment Release the PTT switch and Lock keyRotate the Channel selector to your Desired channelOFF TK-2200 OperatingTK-3200 Operating Press the Lock key or Scan key to select QT or DQT setup New tone or code Tone number or the Scan key toQT Channel Settings Off103.5 Hz 167.9 Hz 107.2 Hz 173.8 Hz DQT DQT Channel SettingsFunction Name KEY Assignment ModeRemaining key Continue to press and hold the key toBe reprogrammed either the Lock key Or the Scan key, while releasingTo save the setting, otherwise Operation will cancelTurn the transceiver power OFF Calling Alert MONITOR/ Squelch OFF Temporary Delete Release the keys ALL Reset ModeTransceiver power on Scan key while turningOptional Accessories Troubleshooting Guide Problem SolutionBattery pack may be dead