Kenwood TK-3200, TK-2200 One or more of the following statements may be applicable

Page 6

One or more of the following statements may be applicable:

FCC WARNING

This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can generate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer for technical assistance.

FCC REGULATIONS REGARDING THE USE OF THE EMERGENCY CHANNEL

The communications must be for the purpose of soliciting or rendering assistance to a traveler, or for communicating in an emergency pertaining to the immediate safety of life or the immediate protection of property.

iv

Image 6 Contents
TK-2200 Thank YOU Operating Conditions FCC License Information Iii Explosive Atmospheres GASES, DUST, FUMES, etcOne or more of the following statements may be applicable Page Contents Warranty card B62-1791-XX Unpacking and Checking EquipmentQuantity Rapid battery charger AC adaptor Ni-MH battery pack Jack coverOrientation Antenna optionalPreparation Pack from the charger INSTALLING/ Removing the Battery Pack Installing the Optional Antenna Installing the Cover Over the SPEAKER/ Microphone Jacks Getting Started Rotate the Channel selector to select your desired channelTurning the transceiver power on Voice Operated Transmission VOXPress and hold the Lock key while Press the Lock key to increase VOX Gain level and the Scan keyTo decrease the level To stop transmitting, stop speaking To exit VOX mode, set the VOX Gain level page 10 to OFFKEY Functions To start scanning, press the Scan key To end Scan, press the Scan key againBackground Operations Quiet Talk QT/ Digital Quiet Talk DQT Channel Setup Mode TK-2200 K2 TK-3200 K2 Channel ModelDesired channel Release the PTT switch and Lock keyRotate the Channel selector to your Press the Lock key to incrementTK-2200 Operating OFFTK-3200 Operating Press the Lock key or Scan key to select QT or DQT setup Tone number or the Scan key to New tone or codeQT Channel Settings Off103.5 Hz 167.9 Hz 107.2 Hz 173.8 Hz DQT Channel Settings DQTKEY Assignment Mode Function NameOr the Scan key, while releasing Continue to press and hold the key toBe reprogrammed either the Lock key Remaining keyTo save the setting, otherwise Operation will cancelTurn the transceiver power OFF Calling Alert MONITOR/ Squelch OFF Temporary Delete Scan key while turning ALL Reset ModeTransceiver power on Release the keysOptional Accessories Troubleshooting Guide Problem SolutionBattery pack may be dead