BenQ MP720 To set a password, If you forget the password, To enter the password recall procedure

Press Auto to Confirm

Press 5 or 6 to change number Press 3 or 4to move

To set a password:

CAUTION: Once a password has been set, the projector cannot be used unless the correct password is entered every time the projector is started.

1.Open the on-screen menu and go to Setting > Password. Select On by pressing Left 3or Right4.

2.	When the function is activated for the first time,	Password Setup
	a prompt will display on the screen. Use the Up	Enter Password	0	0	0	0
	5 or Down 6 button to select a number for

each digit of the password. Use the Left 3 or Right4 button to move between the digits of the password.

3.When all digits are entered and the password is

ready, press Auto to confirm. A confirmation message displays.

• The password will display on-screen when being input.

•IMPORTANT: Write your selected password down here in this manual so that it is available to you should you ever forget it.

Password: __ __ __ __

Keep this manual in a safe place.

4.Perform one of the following 3 steps.

i.Press Auto to continue. The set-up is finished when the message “Password setup

completed” displays.

ii.Press Up 5 to go back to the previous screen and re-enter four digits.

iii.Press Down 6 to cancel the

Password Setup

Do you want to use 0 0 0 0 as your password?

Yes Auto No 5 Cancel 6

password set-up and return to the on-screen menu.

If you forget the password:

You will be asked to enter the four digit password every time you turn on the projector. If you enter the wrong password, the password error message displays. You can retry by pressing Up 5, pressing Power to turn off the projector and start again, or if you did not record the password in this manual, and you absolutely do not remember it, you can use the password recall procedure.

To enter the password recall procedure:

Press and hold Right4 for 5 seconds. The projector will display a coded number on the screen. Seek help from the local BenQ service center to decode the number. You may be required to provide proof of purchase documentation to verify that you are an authorized user of the projector.

To change the password:

1.Open the on-screen menu and go to Setting > Change Password.

2.Press Left 3 or Right4. A “Password Change” message displays.

3.Enter the old password.

i.If the password is correct, you can go on to enter new password.

26 Operation