Safety Instructions (Continued)
6. | Do not place this projector in any of the 7. | Do not block the ventilation holes. | |
| following environments. | - Do not place this unit on a blanket, | |
| - Space that is poorly ventilated or confined. | bedding or any other soft surface. | |
| - Do not cover this unit with a cloth or any | ||
| Allow at least 50 cm clearance from walls | ||
| and free flow of air around the projector. | other item. | |
| - Locations where temperatures may | - Do not place inflammables near the | |
| become excessively high, such as the | projector. | |
| inside of a car with all windows rolled up. |
|
|
|
|
| |
| - Locations where excessive humidity, dust, |
|
|
| or cigarette smoke may contaminate |
|
|
| optical components, shortening the |
|
|
| projector’s life span and darkening the |
|
|
| image. |
|
|
|
|
|
|
If the ventilation holes are seriously obstructed, overheating inside the unit may result in a fire.
8. Always place the unit on a level, horizontal surface during operation.
- Do not use if tilted at an angle of more than 10 degrees left to right, nor at angle of more than 15 degrees front to back. Using the unit when it is not fully horizontal may cause a malfunction of, or damage to, the lamp.
- Locations near fire alarms
- Locations with an ambient temperature above 40°C / 104°F
- Locations where the altitudes are higher than 10000 feet.
9. Do not stand the unit on end vertically. Doing so may cause the unit to fall over, causing injury or resulting in damage to the unit.
Important safety instructions | 3 |