IMPORTANT: Write your selected password down here in this manual so that it is available to you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
ii.If the password is incorrect, a “Password Error” message displays. Press Up 5 to try again or press Down 6 to cancel.
4.Check the new password.
i.Pressing Auto completes the procedure.
ii.Press Up 5 to try again.
iii.Press Down 6 to cancel the
Adjusting the height
The projector is equipped with 1
1.Lift the projector up and press the adjuster button to release the
adjuster. The adjuster will drop into position and be locked.
Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
Be careful when you press the adjuster button as it is close to the exhaust vent where hot air comes from.
2.Screw the rear adjuster foot to fine tune the horizontal angle.
To retract the foot, hold up the projector while pressing the front adjuster button, then slowly lower the projector. Screw the rear adjuster foot in a reverse direction.
If the screen and the projector are not perpendicular to each other, the projected image becomes vertically trapezoidal. To correct this situation, adjust the value of Keystone in the Picture menu, on the projector control panel, or on the remote control. Refer to "Correcting keystone" on page 28 for details.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press Auto on the control panel of the projector or on the remote control. Within 3 seconds, the
The current source information will be displayed at the bottom right of the screen for 3 seconds.
The screen will be blank while Auto is functioning.
Operation 27