BenQ W20000 Using the preset and user modes, Selecting a preset mode, Using the remote control

W20000-en.book Page 24 Monday, October 22, 2007 3:35 PM

English

Using the preset and user modes

Selecting a preset mode

The projector is preset with several pre-defined picture modes so that you can choose one to suit your operating environment and input source picture type.

To select a picture mode that suits your need:

•	Using the remote control
1.	Press PRESET repeatedly or USER 1, USER 2/ISF NIGHT, USER 3/ISF
	DAY on the remote control, or PRESET MODE on the projector
	repeatedly until your desired mode is selected.
•	Using the OSD menu
1.	Press MENU and then press		/	until the Picture -- Basic menu is
2.	highlighted.
	Press	to highlight Picture Mode.			2	3
3.	Press	/ until your desired mode is selected.			Picture -- Basic
						Picture Mode	Cinema
These modes consist of preset values suitable for various projection situations						Load Settings From
						Brightness	+50
as described below:						Contrast	+50
						Color	+50
						Tint	0
•	Cinema: with well-balanced color saturation and contrast with a low					Sharpness	+ 2
						Reset Picture Settings
	brightness level. This is most suitable for enjoying movies in a totally					Rename User Mode

dark environment (as you would find in a commercial cinema). S-Video EXIT Back

•Dynamic: Maximizes the brightness of the projected image. This mode is suitable for environments where extra-high brightness is required, such as using the projector in well lit rooms.

•Standard: Is slightly brighter than Cinema mode, and suitable for use in rooms where there is a small amount of ambient light.

•User 1/User 2/User 3: Recalls the customized settings. See "Setting the User 1/User 2/User 3 mode" on page 25 for details.

Fine-tuning the selected picture mode

The pre-defined picture mode settings can be altered via the available items shown in the Picture -- Basic and Picture -- Advanced menus.

To fine-tune the picture mode:

1.Press MENU and then press / until the Picture -- Basic or Picture -- Advanced menu is highlighted.

2.Press to highlight the item you want to adjust (from among Brightness, Contrast, Color, Tint, Sharpness, Black Level, Clarity Control, Color Temperature, Gamma Selection, Brilliant Color, Color Management, IRIS) and press / to set your desired value. Your selection is automatically stored in the projector and associated with that input source.

See "Fine-tuning the picture quality" on page 26 and "Advanced picture quality controls" on page 27 for

details.

Each time you change the picture mode, the projector also changes the setting to the one which was last set for that particular picture mode on that particular input. If you change the input source, the most recently used picture mode and settings for that input and resolution will be restored.

24 Using the projector