BenQ PB8263 user manual Connector panel

Page 12

Connector panel

21

22

23

24

	21.	RGB (PC)/Component video
		(YPbPr/ YCbCr) signal input
		socket
	22.	RGB signal output socket
25	23.	Audio (Left/ Right)/Video input
		sockets
	24.	S-Video input socket
26	25.	DVI-I signal input socket
		supports DVI-D video signal and
		DVI-A PC signal
27	26.	RS 232 control port
28		For external control systems and
28		used by service personnel.
		used by service personnel.
	27.	PC Audio input socket
	28.	USB socket

12 Introduction

Image 12

Contents Welcome Copyright DisclaimerTable of contents Temperature information Important safety instructions Safety InstructionsSafety Instructions Locations near fire alarms Locations with an ambient temperatureBedding or any other soft surface Allow at least 50 cm clearance from wallsSafety Instructions Projector features IntroductionIntroduction Shipping contents Projector exterior view Front/upper sideRear/side view Lower viewConnector panel Controls and functions ProjectorRemote control LED indicator light Volume +PIP POS ModeRemote control effective range Remote control batteriesPositioning your projector Choosing a locationSafety instructions for ceiling mounting of the projector Obtaining a preferred projected image size Page Maximum zoom Minimum zoom Screen Center of lens Projection distance1219 1500Connecting a computer or monitor Connecting a computerConnection Connection Connecting a monitor With a VGA cable With a VGA to DVI-A cableVGA to DVI-A Connecting Video source devices Connecting AudioBest video quality Better video qualityConnecting a DVI source device Mute on page 45 for detailsConnecting a Component Video source device 1080i 50/ 60 HzConnecting an S-Video source device Connecting a composite Video source device Power on OperationStart up Switching input signal Adjusting the projected imageAdjusting the projection angle Auto-adjusting the image Fine-tuning the image size and clarityAny problems? Searching for details on the imageSelecting the aspect ratio Scales an image so that it is displayed in the centerOptimizing the image Correcting keystoneFor example Selecting a preset mode PC/DVI-A Signal InputYPbPr/YCbCr/DVI-D/S-Video/Video Signal Input Other adjustments Adjusting brightnessAdjusting contrast Selecting a color temperatureOperating in a high altitude environment Personalizing the projector menu displayUsing the laser pointer in the presentation Hiding the imageRemote paging operations Freezing the imageOperation on the remote control PIP Picture In Picture operationOperation in the OSD menus Shutting down the projector On-Screen Display OSD menu operation OSD menu systemUsing the menus Pressing Left/ Right on the projector or remote controlDisplay menu Display menu Image menu Volume Source menuMirror TrebleControl menu PIP menu Maintenance Care of the projectorAccess to the rear dust filter is located on the left side Front filterRear filter Use and replacement of the lamp Lamp informationReplacing the lamp Temperature information Re-install the lamp cover and tighten the screwsReset lamp hours and press Exit to leave Indicators Stand-by modeIllustration Projector is under normal operationPower Temp Lamp Thermal events Troubleshooting Remote control does not workProjector does not turn on No pictureRemote mouse function does not work Specifications Projector specificationsDimensions Timing chartHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Supported timing for PC including DVI-I inputSignal Format Horizontal Frequency Vertical Frequency KHz Supported timing for Component-YPbPrinputSupported timing for Video and S-Video inputs Warranty Limited WarrantyRegulation Statements FCC statementEEC statement MIC statement