BenQ PB8263 user manual Remote control

Remote control

1

2

3

4

5

6

7

8

9

10

11

12	2.	ASPECT
		Selects an image aspect ratio to suit the
13		input signal. See "Selecting a preset
14		mode" on page 35 for details.
	3.	SOURCE
15		Sequentially selects the input signal
		Analog RGB, DVI-A, DVI-D, Analog
		YPbPr, S-Video, or Composite Video.
		See "Switching input signal" on page 31
		for details.
16	4.	UP, DOWN
		When the On-Screen Display (OSD) is
6		activated, press UP to exit and save
		the menu settings.
4
		Press DOWN to open the OSD
17		menu and move the selection focus up

18and down. See "Using the menus" on

	page 42 for details.
5.	MUTE
19	Toggles the projector audio between on
	and off.
6.	Left, Right

20	Correct keystoning at the top or
	bottom of the projected image.
	When the on-screen menu is activated,
	moves the selection focus left or right,
	or make adjustments.
	See "Correcting keystone" on page 34
	and "Using the menus" on page 42 for
	details.
7.	AUTO

1. I Power

Toggles the projector between standby mode and on.

When the projector is in standby mode, press once to turn the projector on. When the projector is on, press twice to turn the projector to standby.

See "Start up" on page 30 and "Shutting down the projector" on page 40 for details.

Automatically determines the best picture settings for the displayed image. See "Auto-adjusting the image" on page 32 for details.

8.MENU

Turns the On-Screen Display (OSD) menu on. Exits and saves the menu settings. See "Using the menus" on page 42 for details.

14 Introduction