Operation
Start up
1.Plug the power cord into the projector and into a wall socket. Turn on the wall socket switch (where fitted).
2.Remove the lens cap. If it is left on, it could become deformed due to the heat produced by the projection
lamp.
3.Turn the main power switch on. The Power
indicator lights orange.
4. | Press and hold (for 2 seconds) | I | Power on | ||
| |||||
| the remote control or projector to start the | ||||
| projector. The Power indicator light flashes | ||||
| green and stays green when the projector is on. | ||||
| The start up procedure takes about 30 seconds | ||||
|
|
| |||
| after pressing | I | Power. In the later stage of | ||
|
| ||||
| start up, a default BenQ logo is projected. | ||||
5. | Switch all of the connected equipment on. | ||||
6. | The projector will start to search for input | ||||
| signals. The current input source being | ||||
| scanned displays in the lower right corner of | ||||
| the screen. The search will continue until an | ||||
| input source signal is detected. | ||||
You can also press SOURCE on the projector or remote control to select your desired input signal. For more information, refer to "Switching input signal" on page 31.
If the frequency/ resolution of the input signal exceeds the projector's operating range, you will see the message “Out of Range” displayed on a blank screen. Please change to an input signal which is compatible with the projector's resolution. See "Timing chart" on page 58 for details.
30 Operation