BenQ PB8263 user manual Safety Instructions

Page 6

Safety Instructions (Continued)

7.The lamp becomes extremely hot during operation. Allow the projector to cool for approximately 45 minutes prior to removing the lamp assembly for replacement.

8.Do not operate lamps beyond the rated lamp life. Excessive operation of lamps beyond the rated life could cause them to break on rare occasions.

9.Never replace the lamp assembly or any electronic components unless the projector is unplugged.

10.Do not place this product on an unstable cart, stand, or table. The product may fall, sustaining serious damage.

11.Do not attempt to disassemble this projector. There are dangerous high voltages inside which may cause death if you should come into contact with live parts. The only user serviceable part is the lamp which has its own removable cover. Under no circumstances should you ever undo or remove any other covers. Refer servicing only to suitably qualified professional service personnel.

6 Important safety instructions

Image 6
Contents Welcome Copyright DisclaimerTable of contents Temperature information Important safety instructions Safety InstructionsSafety Instructions Bedding or any other soft surface Locations near fire alarmsLocations with an ambient temperature Allow at least 50 cm clearance from wallsSafety Instructions Projector features IntroductionIntroduction Shipping contents Rear/side view Projector exterior viewFront/upper side Lower viewConnector panel Controls and functions ProjectorRemote control PIP POS LED indicator lightVolume + ModeRemote control effective range Remote control batteriesPositioning your projector Choosing a locationSafety instructions for ceiling mounting of the projector Obtaining a preferred projected image size Page 1219 Maximum zoom Minimum zoomScreen Center of lens Projection distance 1500Connecting a computer or monitor Connecting a computerConnection Connection Connecting a monitor With a VGA cable With a VGA to DVI-A cableVGA to DVI-A Best video quality Connecting Video source devicesConnecting Audio Better video qualityConnecting a DVI source device Mute on page 45 for detailsConnecting a Component Video source device 1080i 50/ 60 HzConnecting an S-Video source device Connecting a composite Video source device Power on OperationStart up Switching input signal Adjusting the projected imageAdjusting the projection angle Any problems? Auto-adjusting the imageFine-tuning the image size and clarity Searching for details on the imageSelecting the aspect ratio Scales an image so that it is displayed in the centerOptimizing the image Correcting keystoneFor example Selecting a preset mode PC/DVI-A Signal InputYPbPr/YCbCr/DVI-D/S-Video/Video Signal Input Adjusting contrast Other adjustmentsAdjusting brightness Selecting a color temperatureOperating in a high altitude environment Personalizing the projector menu displayRemote paging operations Using the laser pointer in the presentationHiding the image Freezing the imageOperation on the remote control PIP Picture In Picture operationOperation in the OSD menus Shutting down the projector On-Screen Display OSD menu operation OSD menu systemUsing the menus Pressing Left/ Right on the projector or remote controlDisplay menu Display menu Image menu Mirror VolumeSource menu TrebleControl menu PIP menu Maintenance Care of the projectorAccess to the rear dust filter is located on the left side Front filterRear filter Use and replacement of the lamp Lamp informationReplacing the lamp Temperature information Re-install the lamp cover and tighten the screwsReset lamp hours and press Exit to leave Illustration IndicatorsStand-by mode Projector is under normal operationPower Temp Lamp Thermal events Projector does not turn on TroubleshootingRemote control does not work No pictureRemote mouse function does not work Specifications Projector specificationsHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz DimensionsTiming chart Supported timing for PC including DVI-I inputSignal Format Horizontal Frequency Vertical Frequency KHz Supported timing for Component-YPbPrinputSupported timing for Video and S-Video inputs Warranty Limited WarrantyEEC statement Regulation StatementsFCC statement MIC statement