Onkyo SR805 instruction manual Specifications, 117

Page 117

Specifications

Amplifier Section

Rated Output Power

TX-SR805:

North American:

130 watts minimum continuous power per channel, 8 ohm loads, 2 channels driven from 20 Hz to 20 kHz, with a maximum total harmonic distortion of 0.05% (FTC)

150 watts minimum continuous power per channel, 8 ohm loads, 2 channels driven at 1 kHz, with a maximum total harmonic distortion of 0.7% (FTC)

160 watts minimum continuous power per channel, 6 ohm loads, 2 channels driven at 1 kHz, with a maximum total harmonic distortion of 0.1% (FTC)

European:

7 ch 180 W at 6 ohms, 1 kHz, 1 ch driven (IEC) Asian:

7 ch 180 W at 6 ohms, 1 kHz, 1 ch driven (IEC)

TX-SR875:

North American:

140 watts minimum continuous power per channel, 8 ohm loads, 2 channels driven from 20 Hz to 20 kHz, with a maximum total harmonic distortion of 0.05% (FTC)

160 watts minimum continuous power per channel, 8 ohm loads, 2 channels driven at 1 kHz, with a maximum total harmonic distortion of 0.7% (FTC)

170 watts minimum continuous power per channel, 6 ohm loads, 2 channels driven at 1 kHz, with a maximum total harmonic distortion of 0.1% (FTC)

European:

7 ch 200 W at 6 ohms, 1 kHz, 1 ch driven (IEC) Asian:

7 ch 200 W at 6 ohms, 1 kHz, 1 ch driven (IEC) Maximum Output Power

TX-SR805:

Asian:

7 ch 230 W at 6 ohms, 1 kHz, 1 ch driven (JEITA)

TX-SR875:

Asian:

7 ch 250 W at 6 ohms, 1 kHz, 1 ch driven (JEITA)

Dynamic Power

 

TX-SR805:

300 W (3, Front)

 

250 W (4, Front)

 

150 W (8, Front)

TX-SR875:

320 W (3, Front)

 

270 W (4, Front)

 

160 W (8, Front)

THD (Total Harmonic

 

Distortion)

0.05% (Power Rated)

Damping Factor

60 (Front, 1 kHz, 8)

Input Sensitivity and

200 mV/ 47 k(LINE)

Impedance

 

2.5 mV/47 k(PHONO MM)

Output Level and

200 mV/ 470 (REC OUT)

Impedance

Phono Overload

70 mV (MM 1 kHz, 0.5%)

Frequency Response

5 Hz–100 kHz/ +1 dB–3 dB (Direct mode)

Tone Control

±10 dB, 20 Hz (BASS)

 

±10 dB, 20 kHz (TREBLE)

Signal to Noise Ratio

110 dB (LINE, IHF-A)

 

80 dB (PHONO, IHF-A)

Speaker Impedance

4–16

Video Section

Input Sensitivity/Output

Level and Impedance 1 Vp-p /75(Component and S-Video Y)

0.7Vp-p /75(Component Pb/Cb,Pr/Cr)

0.28Vp-p /75(S-Video C) 1 Vp-p /75(Composite)

Component Video

 

Frequency Response

5 Hz – 100 MHz, –3 dB

Tuner Section

FM

Tuning Frequency Range

North American:

87.5 MHz– 107.9 MHz

European and Asian:

87.5 MHz– 108.0 MHz

AM

Tuning Frequency Range

 

North American:

530 kHz–1710 kHz

European:

522 kHz–1611 kHz

Asian:

522 kHz–1611 kHz

 

530 kHz–1710 kHz

Preset Channel

40

General

Power Supply

AC 120 V, 60 Hz

 

AC 220-240 V, 50/60 Hz

 

AC 220-240 V, 50/60 Hz

Power Consumption

 

North American:

9.5 A

European and Asian:

870 W

Dimensions

435 194 458.5 mm

(W H D)

 

17-1/8" 7-5/8"18-1/16"

Weight

 

North American:

23.1 kg

50.9lbs. European and Asian: 23.3 kg

51.4 lbs.

Video Input

HDMI

TX-SR805:

IN 1, IN 2, IN 3

TX-SR875:

IN 1, IN 2, IN 3, IN 4

Component

IN 1 (DVD), IN 2, IN 3

Composite

AUX 1, GAME/TV, CBL/SAT,

 

VCR/DVR, DVD, AUX 2

S-Video

AUX 1, GAME/TV, CBL/SAT,

 

VCR/DVR, DVD, AUX 2

Video Output

HDMI

OUT

Component

MONITOR OUT

Composite

VCR/DVR OUT, MONITOR OUT

S-Video

VCR/DVR OUT, MONITOR OUT

Audio Inputs

Digital Inputs

COAXIAL (IN 1, IN 2, IN 3),

 

OPTICAL (IN 1, IN 2), DIGITAL

Analog Inputs

PHONO, CD, TAPE, AUX 1, GAME/TV,

 

CBL/SAT, VCR/DVR, DVD, MULTI CH

 

(FRONT, CENTER, SUBWOOFER,

 

SURR, SURR BACK), AUX 2

Multichannel Inputs

7.1 ch

117

Image 117
Contents TX-SR875 TX-SR805 Avis Important Safety InstructionsPower PrecautionsFor models having a power cord with a polarized plug FCC Information for UserFor British models PrecautionsContents Features Make sure you have the following accessories Supplied AccessoriesPower cord THX Ultra2Multiroom Capability Main RoomZone 2 Room Zone 3 Room Front Panel Getting to Know the AV ReceiverGetting to Know the AV Receiver Display Rear Panel Digital Optical in 1, 2, and OUT Digital Coaxial in 1, 2,GND screw Front L/R, CENTER, Surr L/R, and Surr Back L/R SpeakersRemote Controller Installing the BatteriesUsing the Remote Controller Remote Controller About the Remote Controller ModesRECEIVER/TAPE Mode Remote Mode buttons Listening Mode buttonsTape mode Standby buttonDVD Mode CD/MD/CDR Modes Dock Mode Enjoying Home Theater Connecting Your SpeakersSubwoofer Surround back left and right speakersConnecting Your Speakers Connecting Your SpeakersConnecting the Speaker Cables Speaker Connection PrecautionsFully insert the bare wire Strip about 5/8Bi-amping Speaker Hookup Bi-amping the Front SpeakersBridged Speaker Hookup Bridging the Front Speakers TX-SR875 onlyConnecting the Indoor FM Antenna Connecting AntennasConnecting the AM Loop Antenna Attach the FM antenna, as shown American ModelConnecting an Outdoor FM Antenna Connecting AntennasConnecting an Outdoor AM Antenna Using a TV/FM Antenna SplitterAbout AV Connections Connecting Your ComponentsOptical Digital Jacks AV Connection Color CodingConnecting Audio and Video Signals to the AV Receiver Connecting Your ComponentsHdmi Monitor Setting Set to Yes Which Connections Should I Use?TV, projector, etc Video Signal Flow Chart DVD player, etc Hdmi Monitor Setting Set to NoAudio Signal Flow Chart DVD player, etc Audio Connection FormatsVideo Connection Connecting a TV or ProjectorAudio Connection HintOr the other Connecting a DVD playerDVD player Hooking Up the Multichannel InputVCR or DVR Connecting a VCR or DVR for PlaybackDigital Optical OUT Connecting a VCR or DVR for RecordingSatellite, cable, set-top box, etc About Hdmi Connecting Components with HdmiSupported Audio Formats About Copyright ProtectionVideo Signals Audio SignalsMaking Hdmi Connections Game Console Connecting a Game ConsoleCamcorder, etc Connecting a Camcorder or Other AV ComponentConnecting a Turntable Connecting a CD PlayerStep CD playerConnecting a Cassette, CDR, MiniDisc, or DAT Recorder Connecting a Power AmplifierPower amplifier European model Connecting an RI DockConnecting the Power Cord Connecting Onkyo ComponentsMalfunction Some components may not support all Functions WorkDo the automatic speaker setup-this is essential Set the Power switch to the on positionTurning On the AV Receiver Turning On and StandbySpeaker Settings First Time SetupHdmi Monitor Setup First Time SetupButtons to select 1. Input/Output Assign, and then press EnterButtons to select Resolution Using the Hdmi OUT ButtonCurrent setting is displayed Press the Hdmi OUT buttonHdmi Input menu appears Hdmi Input SetupVersion OUTFirst Time Setup Assign, and then press Component Video Input SetupInput/Output Assign menu AppearsChanging the Input Display These are the default assignments Digital Input SetupDigital Input menu appears Input selector Audio inputUsing the Digital Input Button Analog Input Setup Buttons to select an input selecTor Using Audyssey MultEQ XT Automatic Speaker Setup Audyssey MultEQ XTMeasurement Positions 1st measurement positionConnect it to the Setup MIC Place the setup microphone atWhen prompted, place the setup Turn on the AV receiverWhen the calculations are com Error MessagesDisconnect the setup micro Phone Plete, the following screenWriting Error Speaker Detect ErrorOne of the front speakers has not been detected One of the surround speakers has not been detectedUsing a Powered Subwoofer Changing the Speaker Settings ManuallyReviewing the Results You want to review, and thenButtons to select 6. Miscella TV Format Setup Not North American modelsNeous, and then press Enter Buttons to select TV FormatHardware Setup menu appears AM Frequency Step Setup on some modelsButtons to select 7. Hardware Buttons to select AM FreqSelect a listening mode and enjoy SettingsSee Using the Listening Modes on Playing Your AV ComponentsTuning into AM/FM Radio Stations Listening to the RadioListening to AM/FM Stations Listening to the Radio Tuning into Stations by FrequencyDisplaying AM/FM Radio Information Followed by the D.TUN buttonWhat is RDS? Using RDS not North American modelRDS Program Types PTY This allows you to search RDS radio stations by type seeDisplaying Radio Text RT Finding Stations by Type PTYListening to Traffic News TP Presetting AM/FM Stations Selecting PresetsDeleting Presets Setting the Display Brightness Adjusting Speaker LevelsCommon Functions Muting the AV ReceiverUsing Headphones Using the Sleep TimerCommon Functions Displaying Source InformationSelecting Audio Inputs Specifying the Digital Signal Format Selecting with the Remote Controller Using the Listening ModesSelecting the Listening Modes Selecting on the AV ReceiverUsing the Listening Modes Listening Modes Available for Each Source FormatAnalog and PCM Sources Sacd DSD, Dolby Digital, and Dolby Digital Plus SourcesDTS-ES TrueHD and DTS SourcesDTS-HD Sources About the Listening Modes Use this mode with any stereo movie e.g., TV, DVD, VHSSound is output by the front left and right speakers DTS NEO6DSD Onkyo Original DSP Modes Recording Recording the Input SourceRecording from Different AV Sources Menu Map Onscreen Setup MenusMain menu SubmenuAdjusting the Listening Modes Using the Late Night FunctionUsing the Re-EQ Function Adjusting the Listening Modes Audio AdjustTone Control Settings Direct Setting Multiplex/Mono SettingsPLIIx/Neo6 Settings Dolby Digital Settings Listening Mode PresetsTheater-Dimensional Setting LFE Level SettingsAudio formats supported by that input selector appear Speaker Setup Advanced SetupSpeaker Settings Buttons to select SubwooferCrossover frequency Advanced SetupDouble Bass Low-Pass Filter for the LFE ChannelSpeaker Distance Speaker Level Calibration Equalizer Settings THX Audio Setup Source Setup Buttons to select THX SubWoofer, and use the Left Name Edit IntelliVolumeSync You want to give a custom nameSatellite Radio When you’ve finished, useSirius Parental Lock Arrow Buttons To display the following screenVolume Setup Miscellaneous SetupVolume Display Maximum VolumeOSD Setup Hardware Setup Remote ControlZone 2 and Zone Analog Multich Lock Setup 100Lock Connecting Your Zone 2 Speakers Directly to the AV receiver Connecting ZoneConnecting Your Zone 2 Speakers to an Amp in Zone Zone 2 and Zone102 Connecting Your Zone 3 SpeakersZone 2 and Zone Zone 2 Video Output TX-SR875 only103 Powered Zone 2 SettingUsing Zone 2 and Zone Zone 2/Zone 3 Out SettingsThis section explains how to use Zone 2 and Zone 104105 On the remote controller, pressSelecting an Input Source for Zones Turning Off ZonesAdjusting the Tone of Zone Adjusting the Volume of Zones Muting ZonesAdjusting the Balance of Zones 106Using a Multiroom Kit with a Cabinet Using a Multiroom Kit with Zone 2/3Using a Multiroom Kit with Other Components 107Entering Remote Control Codes Controlling Other Components108 Remote Control Codes for Onkyo Components Connected via Resetting the Remote ControllerResetting the Remote Mode Buttons 109CH +/-, TV CH + 110CH + Eject111 Learning Commands112 Using MacrosMaking Macros Running Macros113 Troubleshooting114 Troubleshooting115 116 117 SpecificationsSpecifications 118Audio Outputs Control TerminalMemo Onkyo U.S.A. Corporation 120Onkyo Europe Electronics GmbH Onkyo Europe UK Office