Onkyo SR805 Connecting Antennas, Connecting an Outdoor FM Antenna, Using a TV/FM Antenna Splitter

Page 26

Connecting Antennas—Continued

Connecting an Outdoor FM Antenna

If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available out- door FM antenna instead.

FM 75

Notes:

•Outdoor FM antennas work best outside, but usable results can sometimes be obtained when installed in an attic or loft.

•For best results, install the outdoor FM antenna well away from tall buildings, preferably with a clear line of sight to your local FM transmitter.

•Outdoor antenna should be located away from possi- ble noise sources, such as neon signs, busy roads, etc.

•For safety reasons, outdoor antenna should be situated well away from power lines and other high-voltage equipment.

•Outdoor antenna must be grounded in accordance with local regulations to prevent electrical shock haz- ards.

■Using a TV/FM Antenna Splitter

It’s best not to use the same antenna for both FM and TV reception, as this can cause interference problems. If cir- cumstances demand it, use a TV/FM antenna splitter, as shown.

TV/FM antenna splitter

To AV receiver

To TV (or VCR)

Connecting an Outdoor AM Antenna

If good reception cannot be achieved using the supplied AM loop antenna, an outdoor AM antenna can be used in addition to the loop antenna, as shown.

Outdoor antenna

Insulated antenna cable

AM loop antenna

Outdoor AM antennas work best when installed horizon- tally outside, but good results can sometimes be obtained indoors by mounting horizontally above a window. Note that the AM loop antenna should be left connected.

Outdoor antenna must be grounded in accordance with local regulations to prevent electrical shock hazards.

26

Image 26

Contents TX-SR875 TX-SR805 Important Safety Instructions AvisFor models having a power cord with a polarized plug PrecautionsPower FCC Information for UserPrecautions For British modelsContents Features Power cord Supplied AccessoriesMake sure you have the following accessories THX Ultra2Zone 2 Room Zone 3 Room Multiroom CapabilityMain Room Getting to Know the AV Receiver Front PanelGetting to Know the AV Receiver Display Rear Panel GND screw Digital Coaxial in 1, 2,Digital Optical in 1, 2, and OUT Front L/R, CENTER, Surr L/R, and Surr Back L/R SpeakersUsing the Remote Controller Remote ControllerInstalling the Batteries RECEIVER/TAPE Mode Remote ControllerAbout the Remote Controller Modes Tape mode Listening Mode buttonsRemote Mode buttons Standby buttonDVD Mode CD/MD/CDR Modes Dock Mode Subwoofer Connecting Your SpeakersEnjoying Home Theater Surround back left and right speakersConnecting Your Speakers Connecting Your SpeakersFully insert the bare wire Speaker Connection PrecautionsConnecting the Speaker Cables Strip about 5/8Bi-amping the Front Speakers Bi-amping Speaker HookupBridging the Front Speakers TX-SR875 only Bridged Speaker HookupConnecting the AM Loop Antenna Connecting AntennasConnecting the Indoor FM Antenna Attach the FM antenna, as shown American ModelConnecting an Outdoor AM Antenna Connecting AntennasConnecting an Outdoor FM Antenna Using a TV/FM Antenna SplitterOptical Digital Jacks Connecting Your ComponentsAbout AV Connections AV Connection Color CodingHdmi Monitor Setting Set to Yes Connecting Your ComponentsConnecting Audio and Video Signals to the AV Receiver Which Connections Should I Use?Audio Signal Flow Chart DVD player, etc Hdmi Monitor Setting Set to NoTV, projector, etc Video Signal Flow Chart DVD player, etc Audio Connection FormatsAudio Connection Connecting a TV or ProjectorVideo Connection HintConnecting a DVD player Or the otherHooking Up the Multichannel Input DVD playerConnecting a VCR or DVR for Playback VCR or DVRConnecting a VCR or DVR for Recording Digital Optical OUTSatellite, cable, set-top box, etc Supported Audio Formats Connecting Components with HdmiAbout Hdmi About Copyright ProtectionMaking Hdmi Connections Video SignalsAudio Signals Connecting a Game Console Game ConsoleConnecting a Camcorder or Other AV Component Camcorder, etcStep Connecting a CD PlayerConnecting a Turntable CD playerPower ampliﬁer Connecting a Cassette, CDR, MiniDisc, or DAT RecorderConnecting a Power Ampliﬁer Connecting an RI Dock European modelMalfunction Some components may not support all Functions Connecting Onkyo ComponentsConnecting the Power Cord WorkTurning On the AV Receiver Set the Power switch to the on positionDo the automatic speaker setup-this is essential Turning On and StandbyFirst Time Setup Speaker SettingsButtons to select 1. Input/Output First Time SetupHdmi Monitor Setup Assign, and then press EnterCurrent setting is displayed Using the Hdmi OUT ButtonButtons to select Resolution Press the Hdmi OUT buttonVersion Hdmi Input SetupHdmi Input menu appears OUTFirst Time Setup Input/Output Assign menu Component Video Input SetupAssign, and then press AppearsChanging the Input Display Digital Input menu appears Digital Input SetupThese are the default assignments Input selector Audio inputUsing the Digital Input Button Tor Analog Input SetupButtons to select an input selec Measurement Positions Automatic Speaker Setup Audyssey MultEQ XTUsing Audyssey MultEQ XT 1st measurement positionWhen prompted, place the setup Place the setup microphone atConnect it to the Setup MIC Turn on the AV receiverDisconnect the setup micro Phone Error MessagesWhen the calculations are com Plete, the following screenOne of the front speakers has not been detected Speaker Detect ErrorWriting Error One of the surround speakers has not been detectedReviewing the Results Changing the Speaker Settings ManuallyUsing a Powered Subwoofer You want to review, and thenNeous, and then press Enter TV Format Setup Not North American modelsButtons to select 6. Miscella Buttons to select TV FormatButtons to select 7. Hardware AM Frequency Step Setup on some modelsHardware Setup menu appears Buttons to select AM FreqSee Using the Listening Modes on SettingsSelect a listening mode and enjoy Playing Your AV ComponentsListening to AM/FM Stations Tuning into AM/FM Radio StationsListening to the Radio Displaying AM/FM Radio Information Tuning into Stations by FrequencyListening to the Radio Followed by the D.TUN buttonRDS Program Types PTY Using RDS not North American modelWhat is RDS? This allows you to search RDS radio stations by type seeListening to Trafﬁc News TP Displaying Radio Text RTFinding Stations by Type PTY Deleting Presets Presetting AM/FM StationsSelecting Presets Common Functions Adjusting Speaker LevelsSetting the Display Brightness Muting the AV ReceiverCommon Functions Using the Sleep TimerUsing Headphones Displaying Source InformationSelecting Audio Inputs Specifying the Digital Signal Format Selecting the Listening Modes Using the Listening ModesSelecting with the Remote Controller Selecting on the AV ReceiverAnalog and PCM Sources Using the Listening ModesListening Modes Available for Each Source Format DSD, Dolby Digital, and Dolby Digital Plus Sources SacdTrueHD and DTS Sources DTS-ESDTS-HD Sources Sound is output by the front left and right speakers Use this mode with any stereo movie e.g., TV, DVD, VHSAbout the Listening Modes DTS NEO6DSD Onkyo Original DSP Modes Recording from Different AV Sources RecordingRecording the Input Source Main menu Onscreen Setup MenusMenu Map SubmenuUsing the Re-EQ Function Adjusting the Listening ModesUsing the Late Night Function Tone Control Settings Adjusting the Listening ModesAudio Adjust PLIIx/Neo6 Settings Direct SettingMultiplex/Mono Settings Theater-Dimensional Setting Listening Mode PresetsDolby Digital Settings LFE Level SettingsAudio formats supported by that input selector appear Speaker Settings Advanced SetupSpeaker Setup Buttons to select SubwooferAdvanced Setup Crossover frequencyLow-Pass Filter for the LFE Channel Double BassSpeaker Distance Speaker Level Calibration Equalizer Settings THX Audio Setup Woofer, and use the Left Source SetupButtons to select THX Sub Sync IntelliVolumeName Edit You want to give a custom nameSirius Parental Lock When you’ve ﬁnished, useSatellite Radio Arrow Buttons To display the following screenVolume Display Miscellaneous SetupVolume Setup Maximum VolumeOSD Setup Zone 2 and Zone Hardware SetupRemote Control Analog Multich Lock Lock Setup100 Connecting Your Zone 2 Speakers to an Amp in Zone Connecting ZoneConnecting Your Zone 2 Speakers Directly to the AV receiver Zone 2 and ZoneZone 2 and Zone Connecting Your Zone 3 Speakers102 Zone 2 Video Output TX-SR875 onlyPowered Zone 2 Setting 103This section explains how to use Zone 2 and Zone Zone 2/Zone 3 Out SettingsUsing Zone 2 and Zone 104Selecting an Input Source for Zones On the remote controller, press105 Turning Off ZonesAdjusting the Balance of Zones Adjusting the Volume of Zones Muting ZonesAdjusting the Tone of Zone 106Using a Multiroom Kit with Other Components Using a Multiroom Kit with Zone 2/3Using a Multiroom Kit with a Cabinet 107108 Entering Remote Control CodesControlling Other Components Resetting the Remote Mode Buttons Resetting the Remote ControllerRemote Control Codes for Onkyo Components Connected via 109CH + 110CH +/-, TV CH + EjectLearning Commands 111Making Macros Using Macros112 Running MacrosTroubleshooting 113Troubleshooting 114115 116 Speciﬁcations 117Audio Outputs 118Speciﬁcations Control TerminalMemo Onkyo Europe Electronics GmbH 120Onkyo U.S.A. Corporation Onkyo Europe UK Office