Onkyo SR805 instruction manual Reviewing the Results, Changing the Speaker Settings Manually

First Time Setup—Continued

Reviewing the Results

	Use the Up and Down [	]/[ ]
	buttons to select the settings that
ENTER	you want to review, and then
	press [ENTER].
	Auto Speaker Setup	AUDYSSEY
	Save
	Review SP Config
	Review SP Distance
ENTER	Review SP Level
	Cancel

The options are:

Review SP Config

Review the speaker configuration settings.

Auto Speaker Setup			AUDYSSEY
Review SP Config
Subwoofer	:		Yes
Front	:	Full Band
Center	:		80Hz
Surround	:		100Hz
Surr Back	:		150Hz
Surr Back Ch	:		2ch

Review SP Distance

Review the speaker distance set- tings.

Auto Speaker Setup		AUDYSSEY
Review SP Distance
Left	:	15ft
Center	:	15ft
Right	:	15ft
Surr Right	:	7ft
Surr Back R	:	7ft
Surr Back L	:	7ft
Surr Left	:	7ft
Subwoofer	:	15ft

Review SP Level

Review the speaker level settings.

Auto Speaker Setup AUDYSSEY

Review SP Level
Left	:	+12dB
Center	:	0dB
Right	:	–12dB
Surr Right	:	+3dB
Surr Back R	:	+4dB
Surr Back L	:	-6dB
Surr Left	:	-3dB
Subwoofer	:	0dB

Press [RETURN] to return to the pre- vious screen.

Changing the Speaker Settings Manually

In some cases, the measurements taken by the automatic speaker setup may not provide usable results. If running the speaker setup a second time doesn’t help, you’ll have to set the speaker settings manually (see pages 86–91).

Notes:

•For THX-certified speakers, the 80 Hz (THX) cross- over frequency is recommended. If you use the auto- matic speaker setup, you’ll need to manually select 80 Hz (THX) for each THX-certified speaker (see page 86).

•Because of the complexities of low-frequency sounds and the way they interact with a room, THX recom- mends setting the subwoofer level and distance manu- ally.

Using a Powered Subwoofer

If you’re using a powered subwoofer, as it outputs very low-frequency sound and its position is usually low down, it may not be detected by the automatic speaker setup. In this case, increase the subwoofer’s volume, select its highest crossover frequency, and then try run- ning the automatic speaker setup again. Note that if the volume is set too high and the sound distorts, it may not be detected, so use an appropriate volume level. If the subwoofer has a low-pass filter switch, set it to Off or Direct. Refer to your subwoofer’s instruction manual for details.

59