Onkyo SR805 instruction manual Connecting Onkyo Components, Connecting the Power Cord, Work

Connecting Your Components—Continued

Connecting Onkyo Components

Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (RCA).

Step 2: Make the necessary connections (see illustration below).

Step 3: If you’re using an MD, CDR, or RI DOCK component, change the Input Display (see page 51).

With (Remote Interactive), you can use the following special functions:

Auto Power On/Standby

When you start playback on a component connected via , if the AV receiver is on Standby, it will automatically turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components

connected via will also go on Standby. This function will not work with components that are connected to an AC OUTLET on the AV receiver.

Direct Change

When playback is started on a component connected via , the AV receiver automatically selects that component as the input source. If your DVD player is connected to the AV receiver’s multichannel input, you’ll need to press the

[AUDIO SEL] button repeatedly and select Multich to hear all channels (see page 70), as the Direct Change func- tion selects the DVD IN L/R jacks.

Remote Control

You can use the AV receiver’s remote controller to control your other -capable Onkyo components. You must enter the appropriate remote control code first (see page 109). And remember to point the remote controller at the AV receiver and not the other component.

Notes:

•	Use only	cables for	connections.			cables
	are supplied with Onkyo players (DVD, CD, etc.).
•	Some components have two				jacks. You can con-
	nect either one to the AV receiver. The other jack is
	for connecting additional			-capable components.

					IN
					L
					R
			HDMI
RS232	IN 4	IN 3	IN 2	IN 1	CD
				ANTENNA
COMPONENT VIDEO				AM	FM75
IN 3	IN 2 IN 1(DVD)

Y
			AUX 1	GAME/TV	CBL/SAT	VCR/DVR	DVD	IR
C /P			V					ZONE 2
								OUT
C /P			S					FRONT
L	L							L
R	R
PHONO	CD	TAPE	AUX 1	GAME/TV	CBL/SAT	VCR/DVR	DVD

• Connect only Onkyo components to	jacks. Con-
necting other manufacturer’s components may cause

REMOTE CONTROL

SURR BACK R

ZONE2 RFRONT RSURR RCENTERSURR L

R

a malfunction.
• Some components may not support all		functions.
Refer to the manuals supplied with your other Onkyo
components.
• While Zone 2 or Zone 3 is on, the Auto Power
On/Standby and Direct Change	functions do not
work.

FRONT R

DVD

e.g., CD player

R L

ANALOG

AUDIO OUT

e.g., DVD player

R L

ANALOG

AUDIO OUT

Connecting the Power Cord

•Before connecting the power cord, connect all your speakers and AV components.

•Connect the power cord to the AV receiver’s AC INLET.

•Plug the other end of the power cord into a suitable wall outlet.

•Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

43