3.Management with Web browser software
3.5MY IMAGE (Still Image Transfer) Display (continued)
Configure the following items from a web browser when MY IMAGE is used. Example: If the IP address of the projector is set to 192.168.1.10:
1)Enter "http://192.168.1.10/" into the address bar of the web browser.
2)Enter the Administrator ID and password and click [Logon].
3)Click [Port Settings] on the main menu.
4)Click the [Enable] check box to open the Image Transfer Port (Port: 9716). Click the [Enable] check box for the [Authentication] setting when authentication is required, otherwise clear the check box.
5)Click the [Apply] button to save the settings.
When the authentication setting is enabled, the following settings are required.
6)Click [Security Settings] on the main menu.
7)Select [Network Control] and enter the desired authentication password.
8)Click the [Apply] button to save the settings.
NOTE • The Authentication Password will be the same for Network Control Port1 (Port: 23), Network Control Port2 (Port: 9715), and Image Transfer Port (Port: 9716).
•The new configuration settings are activated after restarting the network connection. When the configuration settings are changed, you must restart the network connection. You can restart the network connection by clicking [Network Restart] on the main menu.
39